TECHNICAL PRODUCT DATA SHEET Industrial Process Ultrasonic Flowmeter IDEAL FOR Titan’s Process Atrato® ultrasonic flowmeter is based on our standard, wide ranging, Atrato® meter but packaged to address the more challenging industrial process and control environment. The body is 316 stainless steel, rated at 20 Bar, and the electronics are built-in and sealed to IP65. The only other wetted materials are PEEK and the customer’s choice of elastomers. These devices are calibrated with a pre-set ‘K’ factor so all meters of the same flow range are fully interchangeable, simplifying assembly and set-up procedures for OEM manufacturers. There are two frequency outputs: PNP and NPN. Two multicolour LEDs indicate signal strength, power malfunctions and pulse outputs. Electrical connections are through a standard M12, four pin, sensor connector. Four flow ranges are available from 2 ml/min to 15 litres per minute, with an accuracy of ±1% over the whole flow range. • Cooling equipment • Drink dispense • Chemical dosing • Industrial Flow monitoring • Semiconductor plant Model Flow range Approx • Ultrasonic technology ±1% of reading 2-100% of range ±2% of reading 0-2% of range • Large turndown ratio • y4” BSP-F fittings / %” NPT-F fittings

process Industrial Process Ultrasonic Flowmeter Ordering Codes Model 71P 72P 74P 76P Seal Material (seal temperature range) V = Viton™ (-20 to +150°C) N = Nitrile (-20 to +100°C) E = EPDM (-30 to +150°C) S = Silicone (-50 to +230°C) K = Kalrez® (-10 to +150°C) Process Fitting Size Q = ¼” Process Fitting Type B = BSP (Female) N = NPT (Female) Internal Tube Materials O = PEEK/316 St St Threaded Port (Both Sides) e.g. 76P-VQB-O is a flow range of 0.1 to 15 L/ min with Viton™ seals, quarter inch BSP fittings and a 316 stainless steel flow tube with PEEK internal fittings with a pre-set ‘K’ factor...