TGM2
7Pages

Catalog excerpts

Product Segments • Ergo Motion • Industrial Motion The TGM2 series is TiMOTION’s most powerful gear motor. It was designed primarily for ergonomic applications like height adjustable workstations and tables, but can be used in many other applications. This economical product allows for fast, smooth and quiet adjustment of built-in spindles through the use of external limit switches. Shafting allows for the mechanical synchronization of dual spindles. General Features Max. rated torque Hall sensors Hexagon hole for the shaft by 9mm diameter Low n

Open the catalog to page 1

Standard Dimensions - Standard Dimensions - Load and Speed CODE Self Locking Force (Nm) Hall Sensor Output With Load No Load 24V DC 32V DC With Load Magnet 24V DC Poles Note 1 Please refer to the approved drawing for the final authentic value. 2 Operational temperature range at full performance: +5°C~+45°C 3 The current & speed in table and diagram are tested with TiMOTION control boxes, and there will be around 10% tolerance depending on different models of the control box. (Under no load condition, the voltage is around 32V DC. At rated load, the voltage output will be around

Open the catalog to page 2

Motor Speed (3800RPM) Speed vs. Torque Load 400 Current vs. Torque Load A Performance Data (24V DC Motor)

Open the catalog to page 3

Motor Speed (2200RPM) Speed vs. Torque Load 400 Current vs. Torque Load 12.0 Performance Data (24V DC Motor)

Open the catalog to page 4

Output Signal Output Torque (mm) See page 6 1 = Drive shaft hole (inner hexagon 9) 2 = One side drive shaft (Ø12, knurling) 3 = Two sides drive shaft (Ø12, knurling) External Limit Switch (TES2) 00 = Without XX = Number of output rotations (between13~17 & 25~35 rotations, factory preset) 4 = wo sides drive shaft (Ø12, with Ø4.8 latch hole) T 5 = Drive shaft hole (inner hexagon 6)

Open the catalog to page 5

TGM2 Ordering Key Appendix Plug 0 = Tinned leads Output Torque 1 = Drive shaft hole (inner hexagon 9mm) 2 = One side drive shaft (Ø12mm, knurling) 12 3 = Two sides drive shaft (Ø12mm, knurling) 4 = wo sides drive shaft (Ø12mm, with Ø4.8mm latch hole) T ø4.8 5 = Drive shaft hole (inner hexagon 6mm)

Open the catalog to page 6

TGM2 Ordering Key Appendix TBS Series - the combination of TGM and TBS TBS Input Torque Note 1 he combinations of TGM and TBS are marked as "v" on the above table. T 2 hen choosing the combination of TBS2 / 3 and TGM7, the hexagonal drive shaft is not required. W 3 hen choosing the combination of TBS1 / 4 / 5 / 9 / 10 and TGM1 / 3 / 4, the extra order of hexagonal drive shaft is needed. W 4 lease refer to the table below for the serial numbers and the dimensions of the component. P Hexagonal drive shaft Terms of Use The user is responsible for determining the suitability of TiMOTION...

Open the catalog to page 7