TGM1
7Pages

Catalog excerpts

Product Segments • Ergo Motion • Industrial Motion TiMOTION’s TGM1 series gear motor was designed primarily for ergonomic applications like height adjustable workstations and tables, but can be used in many other applications. This economical product allows for fast, smooth and quiet adjustment of built-in spindles through the use of external limit switches. Shafting allows for the mechanical synchronization of dual spindles. General Features Max. rated torque Hall sensors Operational temperature range at full performance Hexagon hole for the shaft by 6 or 9.1mm diameter Low

Open the catalog to page 1

Standard Dimensions Without TES2 Standard Dimensions With TES2 Load and Speed CODE Self Locking Force (Nm) Hall Sensor Output With Load No Load 24V DC 32V DC With Load Magnet 24V DC Poles Note 1 Please refer to the approved drawing for the final authentic value. 2 he current & speed in table and diagram are tested with TiMOTION control boxes, and there will be around 10% tolerance T depending on different models of the control box. (Under no load condition, the voltage is around 32V DC. At rated load, the voltage output will be around 24V DC

Open the catalog to page 2

Motor Speed (3800RPM) Speed vs. Torque Load 400 Current vs. Torque Load 10.0 Performance Data (24V DC Motor)

Open the catalog to page 3

Motor Speed (3400RPM) Speed vs. Torque Load 400 Current vs. Torque Load 10.0 Performance Data (24V DC Motor)

Open the catalog to page 4

Motor Speed (2600RPM) Speed vs. Torque Load 400 Current vs. Torque Load 10.0 Performance Data (24V DC Motor)

Open the catalog to page 5

Output Signal Output Torque (mm) See page 7 1 = Drive shaft hole (inner hexagon 9.1) External Limit Switch (TES2) 00 = Without XX = Number of output rotations (between13~17 & 25~35 rotations, factory preset) 5 = Drive shaft hole (inner hexagon 6)

Open the catalog to page 6

TGM1 Ordering Key Appendix Plug 0 = Tinned leads Output torque 1 = rive shaft hole (inner hexagon D 9.1) 5 = Drive shaft hole (inner hexagon 6) Input Torque Note 1 he combinations of TGM and TBS are marked as "v" on the above table. T 2 hen choosing the combination of TBS2 / 3 and TGM7, the hexagonal drive shaft is not required. W 3 hen choosing the combination of TBS1 / 4 / 5 / 9 / 10 and TGM1 / 3 / 4, the extra order of hexagonal drive shaft is needed. W 4 lease refer to the table below for the serial numbers and the dimensions of the component. P Hexagonal drive shaft Terms of Use...

Open the catalog to page 7