Product Segments • Comfort Motion TiMOTION’s TA43 linear actuator can fulfill a manufacturer’s seating requirement for small installation dimensions. Although small, this linear actuator provides great force. The compact design is merely 100mm, with a maximum stroke length of 300mm, yet can withstand a maximum pressure of 4000N. General Features Max. load Retracted length Output signals Operational temperature range

Standard Dimensions (mm) Load and Speed CODE Load (N) Push Pull Self Locking Force (N) No Load With Load No Load With Load 4129 Motor Speed (4100RPM, Duty Cycle 10%) 4129 Motor Speed (4500RPM, Duty Cycle 10%) 1 Please refer to the approved drawing for the final authentic value. 2 The current & speed in table are tested with 24V DC motor. 3 This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 4 The current & speed in table are tested when the actuator is extending under push load....

Motor Speed (4100RPM) Speed vs. Load 14.0 Performance Data (24V DC Motor)

Motor Speed (4500RPM) Speed vs. Load 9.0 8.0 7.0 Performance Data (24V DC Motor)

Rear Attachment (mm) See page 7 1 = Plastic, U clevis, slot 6.2, depth 13.5, hole 8.2 Front Attachment (mm) See page 7 2 = Punched hole on inner tube + plastic cap, without 7 = Aluminum casting, U clevis, width 6.2, depth 17.0, slot, hole 10.2 hole 8.2 5 = Plastic, without slot, hole 8.2, with plastic T-bushing 8 = Aluminum casting, U clevis, width 6.2, depth 17.0, hole 10.2 6 = Plastic, without slot, hole 10.2, with plastic T-bushing Direction of Rear Attachment (Counterclockwise) See page 7 Special Functions for Spindle Sub-Assembly Functions for Limit Switches See page 8 1 = Two switches at...

qo t moTion Retracted Length (mm) 2. Retracted length needs to > Stroke+Y

TA43 Ordering Key Appendix Rear Attachment (mm) 1 = Plastic, U clevis, slot 6.2, depth 13.5, hole 8.2 2 = Plastic, U clevis, slot 6.2, depth 13.5, hole 10.2 Front Attachment (mm) 7 = Aluminum casting, U clevis, width 6.2, depth 17.0, hole 8.2 6 = Plastic, without slot, hole 10.2, with plastic T-bushing 5 = Plastic, without slot, hole 8.2, with plastic T-bushing 2 = Punched hole on inner tube + plastic cap, without slot, hole 10.2 8 = Aluminum casting, U clevis, width 6.2, depth 17.0, hole 10.2 Direction of Rear Attachment (Counterclockwise

TA43 Ordering Key Appendix Functions for Limit Switches Wire Definitions CODE Pin • 1 (Green) 2 (Red) O 3 (White) 4 (Black) 5 (Yellow) A (Blue) 1 extend (VDC+) N/A N/A N/A retract (VDC+) N/A 3 extend (VDC+) common upper limit switch N/A retract (VDC+) lower limit switch C = Y cable (For direct cut system, water proof, anti pull) Cable Length for Direct Cut System (mm) U = Molex 6P 3.0 pitch, 180° plug The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change without prior notice.