Product Segments • Comfort Motion • Industrial Motion TiMOTION’s TA38 series linear actuator is specially designed for low-noise applications, or where a compact linear actuator is needed. The TA38 features a very slim design with a small installation size of only 160mm, providing manufacturers great freedom during the design process. The palm sized motor with up to 1500N force is excellent for all kinds of space limited products. General Features Max. load Retracted length ≥ 160mm (depending on chosen options) Stroke 20~200mm Output signals Hall sensors Operational temperature range

Standard Dimensions (mm) Retracted Length Load and Speed CODE Self Locking Force (N) Motor Speed (6000RPM, Duty Cycle 10%) B Note 1  Please refer to the approved drawing for the final authentic value. 2  This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 3  The current & speed in table are tested with 24V DC motor. With a 12V DC motor, the current is approximately twice the current measured in 24V DC; speed will be similar for both voltages. 4  The current & speed in table are...

Motor Speed (6000RPM, Duty Cycle 10%) Speed vs. Load 60.0 Performance Data (24V DC Motor)

Rear Attachment (mm) See page 5 E = luminum casting, U clevis, width 5.2, depth 12.2, A hole 6.2 G = luminum casting, U clevis, width 5.2, depth 12.2, A hole 8.2 Front Attachment (mm) See page 5 E = luminum casting, U clevis, width 5.2, depth 12.2, A hole 6.2 G = luminum casting, U clevis, width 5.2, depth 12.2, A hole 8.2 Direction of Rear Attachment (Counterclockwise) See page 6 Special Functions for Spindle SubAssembly Functions for Limit Switches See page 6 1 = wo switches at full retracted / extended positions T to cut current Output Signals 1 = DIN 6P, 90° plug 2 = Tinned leads 4 = Big...

TA38 Ordering Key Appendix Retracted Length (mm) 1. Calculate A+B = Y 2. Retracted length needs to ≥ Stroke+Y A. Front Attach. Rear Attach. Rear Attachment (mm) E = luminum casting, U clevis, A width 5.2, depth 12.2, hole 6.2 G = luminum casting, U clevis, A width 5.2, depth 12.2, hole 8.2 Front Attachment (mm) G = luminum casting, U clevis, A width 5.2, depth 12.2, hole 8.2 ø17 E = luminum casting, U clevis, A width 5.2, depth 12.2, hole 6.2

TA38 Ordering Key Appendix Direction of Rear Attachment (Counterclockwise) 1 = 90° (Standard) Functions for Limit Switches Wire Definitions CODE extend (VDC+) retract (VDC+) extend (VDC+) upper limit switch retract (VDC+) lower limit switch

TA38Ordering Key Appendix Connector 1 = DIN 6P, 90° plug C = cable (direct cut, water proof, anti-pull) Y Cable Length for Direct Cut System (mm) Terms of Use The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change without prior notice.