Product Segments • Comfort Motion TA32 is a head tilt motor for recliner applications. It can help with adjusting the top head position which will make the end users with more pleasant using experience. General Features Voltage of motor Maximum load in push Maximum speed at full load 8.8mm/s (with 300N in a push condition) Minimum installation dimension

Drawing Standard Dimensions (mm) Load and Speed CODE Load (N) Typical Current (A) Typical Speed (mm/s) Push Pull No Load With Load No Load With Load Motor Speed (5000RPM, duty cycle 10%) 1 This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 2 The current & speed in table are tested when the actuator is extending under push load.

Motor Speed (5000RPM, Duty cycle 10%) Speed vs. Load Performance Data (24V DC Motor)

Rear Attachment (mm) See page 5 1 = Plastic, U clevis, width 6.6, depth 18.6, hole 10.0 Front Attachment (mm) See page 5 1 = Plastic, U clevis, width 6.6, depth 18.6, hole 10.0 Direction of Rear Attachment (Counterclockwise) See page 5 Special Functions for Spindle SubAssembly Functions for Limit Switches See page 6 1 = Two switches at full retracted / extended positions to cut current 3 = Two switches at full retracted / extended positions to send signal Output Signals 1 = DIN 6P, 90° plug 2 = Tinned leads 1 = Straight, 500 2 = Straight, 750 3 = Straight, 1000 5 = Two Hall sensors 3 = Small...

TA32 Ordering Key Appendix Rear Attachment (mm) 1 = Plastic, U clevis, width 6.6, depth 18.6, hole 10.0 Front Attachment (mm) 1 = Plastic, U clevis, width 6.6, depth 18.6, hole 10.0 21.8 ø10 Direction of Rear Attachment (Counterclockwise) 1 = 0°

TA32 Ordering Key Appendix Functions for Limit Switches • 1 (Green) 2 (Red) O 3 (White) 4 (Black) 5 (Yellow) A (Blue) 1 extend (VDC+) N/A N/A N/A retract (VDC+) N/A 3 extend (VDC+) common upper limit switch N/A retract (VDC+) lower limit switch 1 = DIN 6P, 90° plug B = Y cable (direct cut, no water proof, no anti - pull) Cable length for direct cut system (mm) L3 The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change without prior notice.