Product Segments • Comfort Motion TiMOTION’s TA26 series electric linear actuator is designed for furniture applications such as recliners or lift chairs. This linear actuator is designed to function as a direct cut system, eliminating the need for a control box, offering a straightforward and cost effective alternative to complex electric actuation systems. General Features Max. load Retracted length Output signals Hall sensor(s) Operational temperature range

Drawing Standard Dimensions (mm) Load and Speed CODE Load (N) Self Locking Force (N) Typical Current (A) Typical Speed (mm/s) Push Pull No Load With Load No Load With Load 1 Please refer to the approved drawing for the final authentic value. 2 This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 3 Operational temperature range at full performance: +5°C~+45°C 4 The current & speed in table are tested with 24V DC motor. With a 12V DC motor, the current is approximately twice the current...

Motor Speed (3800RPM, Duty Cycle 10%) Speed vs. Load 30.0 Performance Data (24V DC Motor)

Load and Speed See page 2 Retracted Length (mm) See page 5 Rear Attachment (mm) See page 5 1 = Plastic, clevis U, slot 6.2, depth 16.0, hole 10.2 Special Functions for Spindle SubAssembly 1 = Plastic, no slot, hole 8.2 4 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 2 = Plastic, no slot, hole 10.2 10.2 3 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole Output Signals 1 = Two switches at full retracted / extended positions to cut current 2 = Two switches at full retracted / extended positions to cut current + 3rd LS to send signal 3 = Two switches at full retracted / extended...

TA26 Ordering Key AppendixRetracted Length (mm) 1. Calculate A+B = Y 2. Retracted length needs to > Stroke + Y 1 For stroke over 200mm, +5mm for each increment of 50mm stroke 1 = Plastic, clevis U, slot 6.2, depth 16.0, hole 10.2 Front Attachment (mm) 1 = Plastic, no slot, hole 8.2 2 = Plastic, no slot, hole 10.2 3 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 8.2 4 = Aluminum casting, clevis U, slot 6.2, depth 17.0, hole 10.2

TA26 Ordering Key AppendixFunctions for Limit Switches Wire Definitions CODE Pin • 1 (Green) 2 (Red) O 3 (White) 4 (Black) 5 (Yellow) A (Blue) 1 extend (VDC+) N/A N/A N/A retract (VDC+) N/A 2 extend (VDC+) N/A middle switch pin B middle switch pin A retract (VDC+) N/A 3 extend (VDC+) common upper limit switch N/A retract (VDC+) lower limit switch 4 extend (VDC+) common upper limit switch medium limit switch retract (VDC+) lower limit switch P = Molex 8P, 90° plug, without anti-clip K = 1 motor direct cut system J = 1 motor direct cut system, with anti-pull cover S = 1+1,2 motors direct cut system,...