Product Segments • Care Motion TiMOTION’s TA10 series linear actuator is primarily used in the medical market. This actuator series handles high loads and is designed with a manual crank attachment. If necessary, medical staff will be able to easily operate the manual crank to adjust the patient bed. In addition, this linear actuator is available with an optional IP54 or 66 rating. General Features Max. load Retracted length Hall sensor(s) Black, grey Operational temperature range With manual crank functi

Retracted Length CODE Load (N) Self Locking Typical Current (A) Typical Speed (mm/s) Push Pull Brake#4 No Load With Load No Load With Load Motor Speed (2600RPM, Duty Cycle 10%) Motor Speed (3400RPM, Duty Cycle 10%) 1 Please refer to the approved drawing for the final authentic value. 2 This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 3 The current & speed in table are tested when the actuator is extending under push load. 4 The current & speed in table and diagram are tested...

Performance Data (24V DC Motor)

Performance Data (24V DC Motor)

Rear Attachment (mm) See page 7 1 = Aluminum CNC, without slot, hole 10.2, for hand crank 2 = Aluminum CNC, without slot, hole 12.2, for hand crank Front Attachment (mm) See page 7 1 = Casting, width 32, hole 10.2 Direction of Rear Attachment (Counterclockwise) See page 7 Functions for Limit Switches See page 8 1 = Two switches at full retracted / extended positions to cut current 2 = Two switches at the retracted / extended positions to cut current with the third one in between to send signal 3 = Two switches at the retracted / extended positions to send signal 4 = Two switches at the retracted...

TA10 Ordering Key Appendix Retracted Length (mm) 2. Retracted length needs to > Stroke+Y *Retracted length : S + 188 Stroke (mm) Load (N) General

1 = Aluminum CNC, without slot, hole 10.2, for hand crank 2 = Aluminum CNC, without slot, hole 12.2, for hand crank Front Attachment (mm) 1 = Casting, width 32, hole 10.2 2 = Casting, width 32, hole 12.2 Direction of Rear Attachment (Counterclockwise) 1 = 0° 2 = 90°

TA10 Ordering Key Appendix Functions for Limit Switches Wire Definitions CODE Pin • 1 (Green) 2 (Red) O 3 (White) 4 (Black) 5 (Yellow) A (Blue) 1 extend (VDC+) N/A N/A N/A retract (VDC+) N/A 2 extend (VDC+) N/A middle switch pin B middle switch pin A retract (VDC+) N/A 3 extend (VDC+) common upper limit switch N/A retract (VDC+) lower limit switch 4 extend (VDC+) common upper limit switch medium limit switch retract (VDC+) lower limit switch 1 = DIN 6P, 90° plug Q = Molex 6P, 90° plug The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION...