Product Segments • Industrial Motion TiMOTION's JP6 series in-line linear actuator shares the same design concept as the JP5 and JP7. Specifically designed for use in industrial applications with moderate loads, it’s capable of withstanding loads up to 3,000N. It is also suitable for product applications that require a compact installation space. With a built-in current control board, the JP6 supports soft-stop and soft-start as well as overcurrent protection. Also, with an optional IP69K rating, it is designed to withstand high temperature, high pressure water jets, as well as the ingress of dust and other solid contaminants. General Features Max. load Retracted length Output signals Hall sensors Operational temperature range Operational temperature range at full performance Storage temperature range

Retracted Length Load and Speed CODE Self-Locking Duty Cycle Force (N) Note 1 Please refer to the approved drawing for the final authentic value. 2 T he current & speed in table are tested with 24V DC motor. With a 12V DC motor, the current is approximately twice the current measured in 24V DC. With a 36V DC motor, the current is approximately two-thirds the current measured in 24V DC. Speed will be similar for all the voltages. 3 The current & speed in table are tested when the actuator is extending under push load. 4 The current & speed in table and diagram are tested with a stable 24V DC power...

Motor Speed (5600RPM) Speed vs. Load 15.0 Performance Data (24V DC Motor)

Rear Attachment (mm) See page 6 2 = Aluminum, slotless, hole 10.2 4 = Aluminum, U clevis, slot 4.2, depth 12.1, hole 10.2 Front Attachment (mm) See page 6 2 = Aluminum, slotless, hole 10.2 4 = Aluminum, U clevis, slot 6.2, depth 13.0, hole 10.2 End of Stroke Overcurrent Protection PCBA Output Signal Load Type 0 = Sample packaging C = Standard package, US fumigated pallet (1219*1016) 1 = Standard package, EU fumigated pallet (1200*800) E = Standard package, US plywood pallet (1219*1016) 5 = Standard package, EU plywood pallet (1200*800)

JP6 Ordering Key Appendix Retracted Length (mm) 1. Calculate A+B+C = Y 2. Retracted length needs to ≥ Stroke+Y A. Front Attach. C. End of Stroke Overcurrent Protection PCBA Load # Load & Speed Type (N) B, C, D

JP6 Ordering Key Appendix Rear Attachment (mm) 4 = Aluminum, U clevis, slot 4.2, depth 12.1, hole 10.2 2 = Aluminum, slotless, hole 10.2 Front Attachment (mm) 4 = Aluminum, U clevis, slot 6.2, depth 13.0, hole 10.2 2 = Aluminum, slotless, hole 10.2 Connector 01 = Tinnded leads Terms of Use The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change without prior notic