Product Segments • Industrial Motion TiMOTION’s JP4 series inline linear actuator is most similar to the JP3, but was designed for industrial applications that require higher load and speed. Its IP69K protection ensures it will withstand high temperature, high pressure water jets, and the ingress of dust and other solid contaminants. For synchronization and position feedback, the JP4 can be equipped with Hall sensors. General Features Voltage of motor Maximum load Maximum load Maximum speed at full load 24mm/s (with 500N in a push or pull condition) Stroke Minimum installation dimension Certificate UL73 Operational temperature range Operational temperature range at full performance Storage temperature range An inline actuator designed for sm

Retracted Length Standard Dimensions Load and Speed CODE Self Locking Force (N) Motor Speed (3800RPM, Duty Cycle 10%) B Note 1  Please refer to the approved drawing for the final authentic value. 2  This self-locking force level is reached only when a short circuit is applied on the terminals of the motor. All the TiMOTION control boxes have this feature built-in. 3  The current & speed in table are tested with 24V DC motor. With a 12V DC motor, the current is approximately twice the current measured in 24V DC; speed will be similar for both voltages. 4  The current & speed in table are tested...

Motor Speed (3800RPM, Duty Cycle 10%) Speed vs. Load Performance Data (24V DC Motor)

Stroke (mm) Retracted Length (mm) Rear Attachment (mm) See page 6 1 = luminum casting, U clevis, slot 4.2, depth 18.0, hole 10.2 A Front Attachment (mm) See page 6 1 = luminum CNC, no slot, hole 13.0 A Direction of Rear Attachment (Counterclockwise) See page 6 Special Functions for Spindle SubAssembly Functions for Limit Switches See page 7 1 = Two switches at full retracted / extended positions to cut current 2 = Two switches at full retracted / extended positions to cut current + 3rd LS to send signal 3 = Two switches at full retracted / extended positions to send signal 4 = Two switches at...

JP4 Ordering Key Appendix Retracted Length (mm) 1. Calculate A+B = Y 2. Retracted length needs to ≥ Stroke + Y A. Rear Attachment 1 B. Load V.S. Stroke Stroke (mm)

JP4 Ordering Key Appendix Rear Attachment (mm) 1 = luminum casting, U clevis, slot A 4.2, depth 18.0, hole 10.2 14 Front Attachment (mm) 1 = Aluminum CNC, no slot, hole 13.0 11.5 Direction of Rear Attachment (Counterclockwise) 1 = 0°

JP4 Ordering Key Appendix Functions for Limit Switches Wire Definitions CODE extend (VDC+) retract (VDC+) extend (VDC+) retract (VDC+) extend (VDC+) upper limit switch retract (VDC+) lower limit switch extend (VDC+) upper limit switch medium limit switch retract (VDC+) lower limit switch Terms of Use The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change without prior notice.