TimeLink microsystems 10MHz Frequency Low Noise Switch, Amplifier and Distributor The TMD2313 equipment provides switching between two 10 MHz frequency sources, amplification and distribution of these frequencies The internal amplifiers ensure a very low phase noise The equipment is in the form of a rack shelf 19 inches high 1 U This model has 12 independent outputs with the following characteristics: • Isolation between channels > - 50 dB • Harmonics <-30 dB • Phase Noise <-162 dB Operations On the front panel, 2 groups of 3 LEDs, combined with 2 push buttons allows • Selects the mode: Automatic or Manual • Selects source in manual mode Source A or Source B • Indicates the source chosen • Indicates the status of the source Remote control Remote control is done via Ethernet connection /IP 10/100 Mbit/s or via http protocol which makes it possible to obtain information on the state of the equipment: • Operating mode • Track status • Channel selection | 0102313 front panel Information contained in this document is subject to changes without further notice. FP21 42A 1 www.timelinkmicro.info TIMELINK MICROSYSTEMS 14 rue Jean Perrin 31100 Toulouse Tel: +33 (0)5 62 87 10 70

TimeLink microsystems © © © © G ©Specifications Inputs Both inputs accept level signals from +10 to +13 dBm ± 1 dBm Outputs The outputs provide a maximum level of + 13 ± 2 dBm on a 50 Ohm load on the 12 available outputs The input / output ratio is 1 The outputs are not isolated Switching The time to detect a fault on an input is <40ms The switching time is < 50ms Redundant AC power 2 x 230V AC Power supply CEE 2P + T socket with mains filter, M / A switch Voltage: 85-264VAC / 47-440Hz Power consumption: <20W to 230VAC over 50 Hz per power supply Connections The input and output signals are done via...