10MHz Low Noise Frequency Switch, Amplifier and Distributor The TMD2216 equipment provides switching between two 10 MHz frequency sources, amplification and distribution of these frequencies The internal amplifiers ensure a very low phase noise The equipment is in the form of a rack shelf 19 inches high 1U This model has 16 independent outputs with the following characteristics: • Isolation between channels >-50 dB • Harmonics <-30 dB Operation On the front panel, 2 groups of 3 LEDs, combined with 2 push buttons allow to Two inputs automated switch 16 Outputs Low noise frequency amplification HTTP Monitoring and Control through a web based interface • Select the mode Automatic or Manual • Select the source in manual mode (Source A or Source B) • Indicate the selected source • Indicate the source status Remote control The remote control of the equipment is done via the network, using HTTP protocol It provides information on the equipment status : • Operating mode • Track status • Channel selection Information contained in this document is subject to changes without further notice. fp2166a1 www.timelinkmicro.com. TIMELINK MICROSYSTEMS 14 rue Jean Perrin 31100 Toulouse Tel. : +33 (0)5 62 87 10 70

Inputs Both inputs accept level signals from +3 to +13 dBm +-1dBm Outputs The outputs provide a maximum level of +13 ± 2 dBm on a 50 Ohm load on the outputs The input / output ratio is 1 +-1dBm The outputs are not isolated Switching Fault detection time is <40ms Switching time is <50ms Redundant AC power 2 * 230V AC Power supply CEE 2P + T socket with mains filter, M / A switch Voltage: 85-264VAC / 47-440Hz Power consumption: <20W to 230VAC over 50 Hz per power supply Connections The input and output signals are done via the rear panel of the equipment The connectors for the two inputs and the 12...