TimeLink microsystems ©©©(DO© TMD1510 Low Noise Frequency Amplifier and Distributor The TMD1510 equipment provides 5MHz to 10MHz frequency source amplification and distribution. The internal amplifiers ensure a very low phase noise The equipment is in the form of a rack shelf 19 inches high 1U This model has 12 independent outputs with the following characteristics: • Insulated outputs by transformer • Harmonics <-30 dB • Phase noise -160dBc for f>=10 KHz Operations On the front panel, 2 LEDs provide the equipment status. ON LED indicates power is on and the FREQ ON LED indicates frequency input detection. Whenever a frequency is detected at the input it is distributed at the 12 outputs. Alarm A dry contact output provides Power and frequency outputs status. FREQUENCY DISTRIBUTOR Information contained in this document is subject to changes without further notice. FP2158A1 www.timelinkmicro.info TIMELINK MICROSYSTEMS 14 rue Jean Perrin 31100 Toulouse Tel: +33 (0)5 62 87 10 70

TimeLink microsystems ©©©(DO©Specifications Inputs Both inputs accept level signals from +1 to +13 dBm Outputs The outputs provide a maximum level of +13 ± 2 dBm on a 50 Ohm load on the 12 available outputs The input / output ratio is 1 +-1dBm AC power 230V AC Power supply CEE 2P + T socket with mains filter, M / A switch Voltage: 85-264VAC / 47-440Hz Power consumption: <20W to 230VAC over 50 Hz per power supply Connections The input and output signals are done via the rear panel of the equipment The connectors for the two inputs and the 12 outputs are insulated BNC Female type The alarm connector...