The TMA1235 display is dedicated to UT & Countdown display. It’s housed in a standard 1U rack. Main functions Simultaneous display of • TU as received on the IRIGB126 input • CT as received on the IRIGB 126 input Display The UT is displayed with Day number, hour, minute, second. CountDown with Hour, minute, second. To be functional, the display must be connected to 230V AC and be connected to the IRIG B Signal (UT, CD): analog modulated signal, coax BNC or twisted pair cabling on BR2 connector. Parameters setting The setting of the display is done via a serial link. The link "Console" allows direct connection to a PC. The display has an automatic operation which depends on the programmed configuration. This configuration is stored in nonvolatile EEPROM memory. It is restored when switching on the display. Brightness is adjustable in steps of 10%. The adjustment is made remotely by the console link. Viewing Angle The viewing angle relative to the axis is very large + 85 ° / - 85 ° which allows optimal viewing of any point within control room Information contained in this document is subject to changes without further notice. Fp21 71 a2 Les informations contenues dans ce document sont susceptibles d'etre modifiees sans preavis. www.timelinkmicro.com. TIMELINK MICROSYSTEMS 14 rue Jean Perrin 31100 Toulouse Tel. : +33 (0)5 62 87 10 70

TimeLink microsystems §©@©u© Interfaces Console : Standard : RS232 - 3 wires Connector : SubD 9 pins female -115200 bauds, 8 bits, no parity 1stop bit. IRIGB input: Standard : IRIG B. 1 KHz carrier amplitude modulated 1/3 : 1/1 Connectors BNC. : Dimensions Height 1U, width 19’, depth 250 mm. Weight 2.7 Kg j Consumption : 10 W MTBF > 100 000 h Rear Face Information contained in this document is subject to changes without further notice. Fp21 71 a2 Les informations contenues dans ce document sont susceptibles d'etre modifiees sans preavis. www.timelinkmicro.com. TIMELINK MICROSYSTEMS 14 rue Jean...