Time Electronics Description A high performance portable multifunction calibrator with voltage, current, and resistance ranges. The 1017 combines precision with simple operation, making it suitable for use in the laboratory or field. Constructed in a compact and durable plastic case with a tilt stand/ carry handle it takes up minimal bench space and is easily transportable. Five DC voltage ranges from 10 mV to 100 V full scale are available, each with a 6-digit (1 ppm) resolution. The DC current range is 100 mA full scale with a 100 nA (1 ppm) resolution. Resistance from 0.01 Ω to 10 kΩ is available 0.01 Ω steps. Stability and Temperature Coefficient Long-term stability is achieved by the use of high quality components and modern resistor technology. The 1017 features a precision reference diode that provides the input to the units active circuitry. The special low-thermal emf terminals reduce errors when working with microvolt signals. Features • DC voltage 10 nV to 100 V • DC current 100 nA to 100 mA • Resistance 10 mΩ to 10 kΩ • Accuracy 0.005 % (50 ppm) • 1 ppm setting resolution • Noise < 2 ppm (0.1 to 1 Hz) • Stability < 5 ppm/day, < 25 ppm/yr • Deviation control - voltage and current • Battery or mains operation Digital Deviation Control Allows the output to be increased and decreased in % terms from 0 to ± 0.999 %. This provides a direct read-out of error and simplifies the recording results for calibration certificates. It enables the user to immediately see if the unit under test is within specification. Applications The 1017 is suitable for calibrating and simulating a wide range of instruments including thermocouples, transducers, 4 to 20 mA and 0 to 10 V transmitters, and platinum resistance thermometers. It can also be used for testing ranges on multimeters and electrical test tools with measurement capabilities. Portable Operation The 1017 can be powered from mains supply or by the internal rechargeable battery pack. Battery operation enables good performance where earth loop and noise pick-up occurs. When the calibrator is plugged into the mains supply the internal batteries will automatically start to recharge. If unplugged from the mains during operation the internal batteries will continue to power the instrument. Full charge allows 12 hours typical use. An LED indicator on the front panel displays the battery condition. Time Electronics Ltd, Unit 5, T O N Business Park, 2-8 Morley Road, Tonbridge, Kent, TN9 1RA, United Kingdom T: +44 (0) 1732 355993 | F: +44 (0) 1732 350198 | [email protected] | ww

Time Electronics Due to continuous development Time Electronics reserves the right to change specifications without prior notice. Time Electronics Ltd, Unit 5, T O N Business Park, 2-8 Morley Road, Tonbridge, Kent, TN9 1RA, United Kingdom T: +44 (0) 1732 355993 | F: +44 (0) 1732 350198 | mail@timee