BASIC-programmable Ethernet Module address: Tibbo Technology Inc., 9F-3, No.31, Lane 169, Kang-Ning St., Hsi-Chih, Taipei, Taiwan 221 web: www.tibbo.com email: [email protected] phone: +886-2-26925443 fax: +886-2-26923139 continued on next page Features 10/100BaseT Ethernet port 2 Dual-function LED control Thickness: 6.5mm One serial port, 8 I/O lines Works with a standard RJ45 jack Height and width of an RJ45 jack About The EM500 is a miniature stand-alone BASIC-programmable embedded module, designed to be used in combination with a standard LED/magnetics RJ45 jack. The combined footprint of the EM500 and a standard jack is only 28.5x18.5mm. The module’s hardware mix, which includes 10/100BaseT Ethernet, a serial port, and 8 I/O lines, has been carefully tailored to address the basic needs of lightweight network-enabled control devices. Compact dimensions, space-saving “vertical slice” mechanical design, low power consumption, and innovative dual-function LED control lines make the module an excellent fit for miniature, cost-sensitive designs. In the near future, the EM500 will also support Wi-Fi communications (using the GA1000 add-on board), as well as external LCD, keypad, and flash disk (via an SPI flash IC). The EM500 can be ordered standalone or in combination with an industry-standard RJ45 jack and/or all discrete components required to complete the circuit. Specifications Based on a second-generation ASIC (T2000). 10/100BaseT, auto-MDIX Ethernet port (no magnetics) One serial port (CMOS-level): Baudrates of up to 460800bps; None/even/odd/mark/space parity modes; 7/8 bits/character modes; Full-duplex mode with optional flow control; Half-duplex mode with direction control; Encoding and decoding of Wiegand and clock/ data streams. 512KB flash memory for firmware and application. 200 bytes of EEPROM space for data storage. 8 general-purpose I/O lines (including 2 interrupt lines). Control lines for two external dual-function status LEDs. Additional control line for a dedicated Ethernet link LED. External reset source required.

BASIC-programmable Ethernet Module address: Tibbo Technology Inc., 9F-3, No.31, Lane 169, Kang-Ning St., Hsi-Chih, Taipei, Taiwan 221 web: www.tibbo.com email: [email protected] phone: +886-2-26925443 fax: +886-2-26923139 © Tibbo Technology Inc. 2010. Tibbo is a registered trademark of Tibbo Technology Inc. Specifications (continued) Power: 260mA @ 3.3V (100BaseT mode). “Vertical slice” construction; dimensions: 18.5x16.0x6.5mm. Firmware is upgradeable through the serial port or network (including “cold upgrade” firmware uploads through the network). To be available later: Optional Wi-Fi interface...