Capacitor discharge stud welding equipment : NOMARK This new line of stud welding equipments meets the highest requirements due to operating convenience, low weight, high efficiency, compact design and absolute safety. The monitoring of all functions is clearly displayed by LED on the front panel. The short charging cycles increase productivity. Lightweight and easily portable, the NOMARK 66 weighs in at around half of many other conventional studwelding equipments. The NOMARK 66 is our capacitor discharge stud welding system that is lightest in weight and lowest in cost. Welding Range : M3 - M8 (in Steel and Stainless Steel) Welding source Welding process Capacitance Charging Voltage Digital Voltmeter Welding time Duty cycle Output power Mains supply Size (w x h x l) Protection Insulation Class Weight M3 - M6 (in Aluminum and Brass) Capacitor battery "Gap" and "Contact" 66.000 µF 50 - 200 V (Bi-directional) Yes 0,001 - 0,003 sec. Up to 25 studs / min 1.320 Ws 230 V - 50 / 60 Hz - 10 AT 165 x 250 x 380 mm IP 23 1 12,5 Kg Gun G1 or C1 Welding range Stud Length range Nail length range Welding process Lift settings (for G1) Spring settings (for C1) Cables length Cables Section: Protection Weight (without cable) M 3 to M 8 6 to 40 mm 6 to 100 mm G1 gun : Gap C1 gun : Contact Infinitely adjustable Infinitely adjustable Gun G1 : 3 meters Gun C1 : 5 meters 25 mm2 IP 2x G1 : 0,7 Kg. C1 : 0,6 Kg. Accessories : Template Tube Ø 30 mm Extension Kit for studs longer than 40 mm Silence Tube Ø 35 mm Chuck Offset Tube for Template Ø 20, 26 et 30 mm. ZI, 3ème RUE B. 6040 JUMET TEL : + 32.71.91.97.60 FAX : + 32.71.91.96.71 Web : www.thomas-welding.com E-Mail: [email protected] Technical data may change without prior notice