Bottle Cap with Integral Probe Clamp and Cannular for Validation Thermocouples Product Code: GL45-1 Description: When using liquid containers fitted with a validation thermocouple in a steriliser, it is often difficult to ensure that the thermocouple hot junction is maintained centrally and at the desired depth within the container during the full sterilising cycle. The GL45-1 makes this a simple operation by having a permanently fitted integral cannular. The cannular is made to the required length and allows the thermocouple hot junction to be held just below the cannular opening. A clamp is permanently fitted to the cap which can be supplied as standard or with a vent hole if required. Duran® is a registered trade mark of Schott Duran Produktions GmbH & Co. KG. Corning® is a registered trade mark of Corning Inc. Teflon® is a registered trade mark of the Dupont Corporation. Thermal Detection Limited Unit 6, Primrose Hill Industrial Estate Orde Wingate Way Stockton-on-Tees, England, TS19 0GA Email: [email protected] Web: www.thermal-detection.com

Bottle Cap with Integral Probe Clamp and Cannular for Validation Thermocouples Validation Accessories: Pre-cut Validation Thermocouples Validation Thermocouple Looms GL45-1 Bottle Cap Gland for Thermocouple Thermocouple Entry Gland TCEG Clamps, Tri-clover Blanks, Gaskets Type T Thermocouple Wire Ampoule Holders Datasheet : 027 Thermal Detection Limited Unit 6, Primrose Hill Industrial Estate Orde Wingate Way Stockton-on-Tees, England, TS19 0GA Fax : +44 (0) 1642 618307 Tel : +44 (0) 1642 602878 Email: [email protected] Web: www.thermal-detection.com © Thermal Detection Ltd 2016