Accuchiller EQ Portable Chiller Compressor Protection Technology Our compressor protection technology uses start-to-start anti-recycle control logic to limit cycling under low-load operating conditions to extend compressor life. Temperature Deviation Warnings and Alarms A warning alerts the operator of a potential problem before a fault occurs and if the condition gets worse, an alarm stops the chiller to prevent damage. Deviation Alarm Time Delays Provides an adjustable alarm time delay to deactivate the alarms long enough for the process loop to stabilize before the alarms are active. Standard Features Direct-Drive Scroll Compressors Direct drive hermetically sealed scroll compressors with proven performance in industrial cooling for reliable, low maintenance, and efficient operation. Stainless Steel Evaporators High-efficiency stainless steel plates with copper brazing provide maximum performance, long life, and an enhanced level of corrosion protection for harsh process conditions. Stainless Steel Pump Stainless steel pump selected for peak performance with the utmost in corrosion protection to ensure a long useful life under severe industrial conditions. Nonferrous Reservoir and Water Lines The insulated reservoir, fluid lines, pumps, and other components in the process fluid circuit will remain free of rust to provide maximum corrosion protection. Evaporator Inlet Strainer The evaporator inlet strainer removes any debris present in the process fluid to prevent costly downtime and repair due to a clogged chiller evaporator. Standard Controller Warranty 12 months parts on entire unit 12 months labor Available Options • Larger pumps • Alarm horn • Automatic make-up • Rotary non-fused disconnect switch • Branch circuit fusing • C-UL508A industrial control panel • Modbus TCP/IP communications • High temperature set point (up to 80°F) • Reservoir low level alarm • Main power phase monitor and alarm • Return

Accuchiller EQ Portable Chiller Air-Cooled Condenser Chiller Model EQ3A01 1 20 to 65 1 ¼ 2 80 11 20 3 255 Cooling tons based on 12,000 BTU/Hr/ton with 50°F leaving coolant and 95°F ambient air, R407c refrigerant. 2 MCA is Minimum Circuit Amps with standard condenser fan and pump under full load, used for minimum wire size requirement. 3 MOP is Maximum Overcurrent Protection with standard condenser fans and pump, used for sizing main power protection device. ½" FPT Automatic Make-up (Optional) 1" FPT To Process Pump Pressure Gauge Water Level Sightglass Air-Cooled Condenser Chillers Model EQ2A03...

Accuchiller EQ Portable Chiller Water-Cooled Condenser Chillers Model EQ2W03 3 20 to 65 1 1 8 38 11 20 11 430 1 Cooling tons based on using R-407c refrigerant with 12,000 BTU/Hr/ton with 50°F leaving coolant and 85°F condenser water. 2 MCA is Minimum Circuit Amps with standard condenser fan and pump under full load, used for minimum wire size requirement. 3 MOP is Maximum Overcurrent Protection with standard condenser fans and pump, used for sizing main power protection device. 1" FPT From Process 1" FPT To Process Pump Pressure Gauge ½" FPT Automatic Make-up (optional) 1" FPT Condenser Water...

Accuchiller EQ Portable Chiller Remote Air-Cooled Condenser Model Chiller used with LAVB11210 EQ2R03 1 3 15 565 Varies based on system charge and operating conditions MCA is Minimum Circuit Amps, used for minimum wire size requirement. 2 MOP is Maximum Overcurrent Protection, used for sizing main power protection devices. 1 Unit MCA @ 460/3/60 with Optional Pump Sizes Pump 5680 W. Jarvis Ave • Niles, IL 60714 847-966-2260 • [email protected] www.thermalcare.com April 2022 Thermal Care is ISO 9001 Certified Manufacturer reserve the right to change specification or design without notification...