SNE-76
2Pages

SNE-76 PIPE END PREPARATION MACHINE clamping range 8 to 76 mm O.D. • short machining time • compact build • fast and safe clamping • easy to operate Pipe and bar ends can be machined in seconds with the SNE-76 pipe end preparation machine. In the head maximum three insert holders can be placed. This makes it possible to machine a pipe in and outside and to face the pipe at the same time. By moving the handle to the left the clamp closes and the end stop goes back automaticly. After that the head moves in the direction of the material. The feed travel can be limited by a stop. The unique SNE-76 is a fast and safe machine for accurate machining of pipes and bar. for • heat exchanger manufacturing • offshore constructions • apparatus manufacture • equipment constructions • shipbuilding • machine construction • pipeline construction

SNE-76 technical specifications SNE-76 general specifications Pipe diameter minimum 6 mm O.D. maximum 76,3 mm O.D. Clamping by means of replaceble clamp shells Speed 250-650 / 450-1200 / 1600 - 3200 rpm Power 0,75 kW Voltage 380/400 Volt, 50/60 Hz Dimensions (Length x Height x Width) 320 x 770 x 660 mm Weight 130 Kg Three insertholders can be placed in the head. Each with one single insert. While the insert holders are in a fixed position, their set up is garuanteed. Even when the inserts must be replaced. The clamp is provided with two replaceable clamping jaws with are conected to the...