Due to its wide performance spectrum, the Testboy Profi LED Plus is one of the most sought after products in ourassortment. The Profi LED Plus combined the following 7 features in one unit: | Display DC and AC voltage from 6 to 1000V | Single – pole phase testing | Two – pole phase sequence indication | Continuity testing up to 500Ω (acoustically / optically) | RCD – testing lever two button | LED torch lamp | Removable 4 mm test tips adaptor The professional appearance is underlined by the mix of materials used in the plastic housing and the rubber handle. The Display area is protected by a break proof plastic disk. Even when in daily use, the robust construction as well as the dust and waterproof housing guarantee a long service life. The test tips are protected by a removable cap that in turn is secured to the device. Also the usage of LED`s for all optical indications guarantee you maximum reliability. When the probe tips are connected to an AC voltage within the nominal voltage range, the reading is displayed in volts and the “+~-” LED indicator lights up. From a voltage more than 35V (life risk) a buzzer sounds up. The switchable load per button impeded the unmeant triggering of the RCD – switch, so that the protective earthing conductor can be measure as well. With throughput testing up to 500kΩ, it sounds an acoustical signal. Your advantages: | 5 years manufacturer’s warranty | TÜV/GS tested and approved | IEC/EN 61243-3 (DIN VDE 0628-401) Technical Details Testboy Profi LED Plus Display optical 12 LEDs Operating panel finger tip / RCD button Measurement range automatic range Voltage range 6 - 1000V AC/DC, 0 - 400Hz Continuity test 0 - 500k with acoustical signal Phase indication > 100V AC Switchable load Is ~ 30mA ED(DT) = 30 sec. Power supply 2x 1,5V Overload category CAT IV 1000V

Dimension 238 x 70 x 30 mm Protection IP 65 Weight 200 g TÜV / GS IEC/EN 61243 - 3 Colour red/black, other colours on request Scope of delivery 1x operating instruction 2x battery type AAA LR03 Supplies, optional bag