Electrical Force Transducers – Model 347 n n n n n n n n n Capacities: 300kN to 5MN For compression Stainless steel High accuracy Sensitivity: 2mV/V Easy installation Suitable for rough environments Optional: TEDS module 1) Female connector incl. cable The electrical force transducers of the model series 347 are used for compressive measurements under rough conditions. The device that is made of stainless steel is easy to install and provides excellent measurement results due to its typical shaping as a massive, cylindrical sensor. On demand you receive model 347 also with a TEDS module inside the plug. Model 347 >> Technical data according to VDI / VDE directive 2638 Zero signal when removed Rated characteristic value Relative error of characteristic value Relative linearity error Relative repeatability error in unchanged mounting position Combined error Reference temperature Rated temperature range Operating temperature range Storage temperature range Relative creep Relative creep Temperature effect on characteristic value per 10K Temperature effect on zero signal per 10K Input resistance Output resistance Insulation resistance Max. excitation voltage Rated range of excitation voltage Limit force Breaking force Max. permissable dynamic load 2) Ldy % 1) TEDS = Transducer Electronic Data Sheet acc. to IEEE 1451.4 TesT Deutschland: Helena-Rubinstein-Straße 4 | 40699 Erkrath | Fon: +49 211 2099030 | Fax: +49 211 209903201 | [email protected] | www.test-gmbh.com TesT Schweiz: Bösch 63 | 6331 Hünenberg | Fon: +41 41 7856010 | Fax:

Electrical Force Transducers – Model 347 TesT Deutschland: Helena-Rubinstein-Straße 4 | 40699 Erkrath | Fon: +49 211 2099030 | Fax: +49 211 209903201 | [email protected] | www.test-gmbh.com TesT Schweiz: Bösch 63 | 6331 Hünenberg | Fon: +41 41 7856010 | Fax: +41 41 7856015 | [email protected] | www.test-ag.