PRODUCT DATA Isco Syringe Pumps Syringe Pump Controller NEW! DISPENSE MODE The D-Series syringe pump controller regulates all pumping functions. It is designed to sit on top of the pump base, but it may also be located elsewhere, depending upon safety and convenience considerations. The rear panel of the pump controller contains input and output connectors. The only operation control included on the pumps themselves is the main power switch. Key Controller Functions ä Constant Flow ä Constant Pressure ä Program Gradient ä Dispense Mode ä Run/Stop ä Refill Operating Modes ä Constant flow or pressure with up to three pumps ä Gradient LC programming External Interface ä RS232 serial interface ä Analog voltage inputs ä Digital inputs and outputs ä Flow or pressure programming with a single pump Teledyne Isco, Inc., 4700 Superior Street, Lincoln, NE 68504 USA Toll free: (800) 228-4373 (USA and Canada) • Phone: (402) 464-0231 • Fax: (402) 465-3022 e-mail: [email protected] • www.isco.com

Pump Controller Key Functions Selects constant flow rate mode CONST PRESS: Selects constant pressure mode PRGM GRAD: Selects gradient mode and accesses gradient programming Activates dispense mode Turns on pump driver motor to move piston upward Turns off pump driver motor to cease piston movememt Enables changes to maximum and minimum pressure and flow limits RAPID PRESS: Allows rapid pressurization to the stable pressure point Accessory control that manually operates accessories such as valves Provides access to operational modes, units, and optional parameters Turns on pump driver motor to...