Model 2348
2Pages

2.0 MHz Power Amplifier for Signal Generators f \ • Precise amplification and voltage stability • ± 25 V with up to 750 mA of output current • Bandwidth from DC to 2.0 MHz • Full power bandwidth, from DC to 500 kHz • Precision voltage monitor • Compatible with most function, sweep, pulse, or arbitrary waveform generators • 1-year warranty v_J Expand Your Signal Generation Limits The Model 2348 is a compact but robust power amplifier designed for applications that require moderate voltage amplification and high current beyond the ranges of arbitrary, function, sweep, or pulse generators. High Current Output The 2348's current capabilities make it ideal as a buffer for signal generation devices used in solenoid or magnetic excitation. This unique amplifier meets requirements for MEMS testing, transducer characterization, and pulse applications. Its high voltage stability and low noise characteristics also meet the demands of mass spectrometry and related scientific applications. A continuous current of 750 mA is available at voltages up to 50 Vp-p. This provides 18.75 W of AC or DC output power to 500 kHz. The instrument's bandwidth ranges from DC to 2.0 MHz. All of this performance is packed into a compact, rack-mountable chassis no larger than a typical function generator. Built in Protection Output current is sensed in either polarity by the 2348's built in current limit function. The 2348 power amplifier is equipped with thermal shutoff to protect against overheating. This maximizes protection to the amplifier's circuitry in the event of an external fault. The main output is isolated from ground. A binding post is provided on the front panel for a direct chassis ground connection. Ideal for Your Test Application An independent, buffered, voltage monitor output is provided for applications that require a low-level representation of the output signal such as in closed loop applications. The monitor output reduces the output signal to 20:1 for 50 D inputs and 10:1 for inputs exceeding 1 MD. The Model 2348 is a cost-effective solution for specialized applications where low distortion and precision is required. The 2348 is ideally suited for high frequency, power applications that require voltage amplification with an abundant supply of current. Contact TEGAM Contact your local TEGAM representative to find out more about the 2348 power amplifier and our other signal amplification solutions. Prices and specifications subject to change without notice. 2348-909 Rev. A

Model 2348 POWER AMPLIFIER Specifications Electrical Specifications Number of Channels Input Impedance Output Voltage Range Maximum Output Current Sine Wave Distortion (THD) Voltage Gain Bandwidth Full Power Bandwidth Slew Rate Square Wave Response (10 %-90 %) Aberrations 1 50 Ω Direct Coupled 0 to ± 25 V Direct Coupled 750 mA See Figure 2 +10 Fixed DC to 2 MHz, 50 Vp-p Full Load (-3 dB) DC to 500 kHz / 50 Vp-p / 750 mA Sine - Typical (-0.4 dB) (RL=33 Ω) >200 V/μs < 0.16 μs for 35 Volt Step RL=23 Ω - Typical <2% 50 Ω Voltage Monitor Output 50 Ω Input Z (20:1 Ratio) > 1 MΩ Input Z (10:1...