TS200MT_TS200BT MEDIAM & LOW VOLTAGE DETECTORSR
2Pages

TS200MT MEDIUM VOLTAGE DETECTOR TS200MT Medium Voltage Detector is a product intended to detect TS200BT Low Voltage Detector is a product intended to detect the events occurring in medium voltage electrical networks up to 34.5 kV. It absence/presence of voltage in electrical networks up to phase-phase uses a system to read the voltage and current in the network, which indicates permanent shutdown and restart events. It uses a system to read the voltage in the network, which detects the The measurements are taken every 10 seconds, and once the system absence/presence of voltage per phase sending a spontaneous event identifies an event, the information is transmitted through the Sigfox® to the distributor's Operations Center. The equipment is flexible to adopt the communication module most The message is then directed to a supervision system, informing the adequate to the topology of the Distributor, initially being offered with identification number as well as all the events detected on the network. Modem Cellular or Sigfox, with a design concept based on low energy This system is responsible for managing the information exchange of consumption. Its power system uses the low voltage network itself all detectors installed by the customer. The information is interpreted associated with ultra-capacitors, which keeps it maintenance-free and converted in DNP3 protocol, receiving a time stamp and allowing andwith an autonomy for up to 40 minutes without the presence of a direct communication with the SCADA of the distributor's Operations TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS FEATURES APPLICATION VOLTAGE: DETECTION RANGE: AUTONOMY: OPERATING TEMPERATURE RANGE: MAINTENANCE-FREE POWER SYSTEM USING A COMBINATION OF ULTRA-CAPACITORS AND SOLAR PANEL LOW POWER CONSUMPTION: AVERAGE OF 10 MWH SIGFOX NETWORK COMMUNICATION OPEN FREQUENCY SENDING POWER TYPICAL APPLICATION INDICATION OF SHUTDOWN AND RESTART EVENTS OF MEDIUM VOLTAGE NETWORKS (UP TO 34,5 KV) OPERATES IN SINGLE OR THREE-PHASE NETWORKS THREE-PHASE VOLTAGE DETECTION OF UP TO 380V BY ISOLATED OPTOCOUPLERS AC MAIN POWER SUPPLY FROM 90V TO 240V AUXILIARY SOURCE OF ULTRA-CAPACITORS WITH AUTONOMY OF 40 MINUTES IP65 PROTECTION DEGREE OPERATING TEMPERATURE RANGE: -30ºC TO 85ºC STORAGE OF UP TO 200 MESSAGES MESSAGE UPDATE EVERY 60 MINUTES COMMUNICATIONS COMMUNICATION VIA SIGFOX NETWORK OR CELLULAR MODEM CELLULAR MODEM WITH PENTA-BAND TECHNOLOGY CAPACITY FOR 2 SIM CARDS DATA SENT TO A SUPERVIOSION SYSTEM THAT CONVERTS THE MESSAGE INTO DNP3 AND FORWARDS TO SCADA OPEN FREQUENCY USAGE TYPICAL APPLICATION DETECTION AND PRESENCE INDICATION VOLTAGE SUPERVISION SYSTEM OPERATIONS CENTER OPERATIONS CENT

TS300S KOALA FUSE MONITORING SYSTEM SMART SENSOR DISTRIBUTION NETWORK MONITORING TS300S Koala and its Supervision System, are intended to support the Networking monitoring system up to 34.5 kV in three-phase distribu- monitoring and maintenance activities of medium voltage power tion networks using intelligent current sensors. It consists of three distribution networks (13.8kV to 34.5kV), and its field installation is sensors and one remote unit, which receives data from the sensors in performed using a ladder and a maneuver stick and it can be installed real time and sends them to the...