Catalogs >
Tecnotion >
TM series 2.2

TM series 2.2
1 / 2Pages

Catalog excerpts

TM Series iron core Parameter Winding type Motortype, max voltage ph-ph 3-phase synchronous Iron core, 400Vac rms (565 Vdc) Peak force @ 6°C/s increase Continuous force* Maximum speed** Motor force constant TM3 on 144mm magnet plate shown Ultimate force @ 10°C/s increase Ultimate current Peak current Motor constant Maximum continuous current* Back EMF phase-phase peak Electrical time constant* Maximum continuous power loss Thermal resistance Thermal time constant* Coil unit length Magnet plate dimensions Motor attraction force Coil unit weight The TM series comes standard with a 3m long FLEX power cable. Temperature cut-off / sensor FLEX Cable Cable mass Magnet plates can be butted together. Cable type (sensor) Cable Life (power FLEX)*** Cable Type (power FLEX) Bending Radius Static Bending Radius Dynamic (power FLEX) All specifications ±10% * These values are only applicable when the mounting surface is at 20°C and the motor is driven at maximum continuous current. If these values differ in your application, please check our simulation tool. ** Actual values depend on bus voltage. Please check the F/v diagram in our simulation tool. *** Depending on bending radius, veloc

Open the catalog to page 1

Magnet plates COIL UNITS 6.5 Optional: Digital Hall Module O 4.3 Thermal sensor cable O 8.3 Power cable MAGNET PLATES Hole O5 ( deep) For Dowelpin DIN7 O5h8 (Optional use) Slotted Hole O5x0.2 (4 deep) For Dowelpin DIN7 O5h8 Magnet plate Slotted Hole O5x0.5 ( deep) For Dowelpin DIN7 O5h8 (Optional use) Hole O5 (4 deep) For Dowelpin DIN7 O5h8 Mounting instructions and flatness or parallelism requirements can be found in the iron core installation manual. CAD files, 3D models and the manual can be downloaded from our website. ©2022 Tecnotion BV - All rights reserved - The contents of this...

Open the catalog to page 2

TM series 2.2 1 / 2Pages

Catalog excerpts

All Tecnotion catalogs and technical brochures

TM series 2.2
1 / 2Pages