Catalogs >
Tecnotion >
QTL 310 Torque motors

QTL 310 Torque motors
1 / 2Pages

Catalog excerpts

Torque QTL 310 series with cooling ring Parameter Winding type Continuous torque Stall torque Peak current Peak torque @ 6°C/s increase Ultimate current Ultimate torque @ 20°C/s increase Motor constant Motor torque constant Motortype max. voltage ph-ph Back EMF phase-phase peak Back EMF phase-phase RMS Coil resistance per phase Coil induction per phase Electrical time constant Continuous power loss Thermal time constant Water cooling flow Water cooling pressure drop Temperature cut-off / sensor Stator OD Please check the T/n diagram in our If these values differ in your application, please check our simulation tool or manual. 4022 363 0300 - Ver. 2.2 3. Rth based on given water flow and pressure. is driven at maximum continuous current. Motor height manual or online simulation tool. mounting surface is at 20°C and the motor 1. Actual values depend on bus voltage. 2. These values are only applicable when the Lamination stack height Rotor inertia Stator mass excluding cables Rotor mass Total mass excluding cables Cable mass Cable type (power)

Open the catalog to page 1

Mounting instructions and tolerances can be found in the torque installation manual. Manuals and 3D CAD files can be downloaded from our website. 81 ©2022 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior no

Open the catalog to page 2

QTL 310 Torque motors 1 / 2Pages

Catalog excerpts

All Tecnotion catalogs and technical brochures

QTL 310 Torque motors
1 / 2Pages