Catalogs >
Tecnotion >
QTL 230 Torque motors

QTL 230 Torque motors
2Pages

Catalog excerpts

Torque QTL 230 series with cooling ring Parameter Winding type Peak torque @ 6°C/s increase Continuous torque Stall torque Ultimate current Ultimate torque @ 20°C/s increase Motor constant Motor torque constant Motortype max. voltage ph-ph Peak current Back EMF phase-phase peak Back EMF phase-phase RMS Coil resistance per phase Coil induction per phase Electrical time constant Continuous power loss Thermal time constant Water cooling flow Water cooling pressure drop Temperature cut-off / sensor Stator OD mounting surface is at 20°C and the motor is driven at maximum continuous current. If these values differ in your application, please check our simulation tool or manual. 4022 363 0300 - Ver. 2.2 3.Rth based on given water flow and pressure. manual or online simulation tool. Motor height Please check the T/n diagram in our 1. Actual values depend on bus voltage. 2. These values are only applicable when the Lamination stack height Rotor inertia Stator mass excluding cables Rotor mass Total mass excluding cables Cable mass Cable type (power) Cable type (sensor

Open the catalog to page 1

Mounting instructions and tolerances can be found in the torque installation manual. Manuals and 3D CAD files can be downloaded from our website. M4 `11 (32x) ©2022 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior

Open the catalog to page 2

QTL 230 Torque motors 2Pages

Catalog excerpts

All Tecnotion catalogs and technical brochures

QTL 230 Torque motors
2Pages