Catalogs >
Tecnotion >
QTL 210 Torque motors

QTL 210 Torque motors
2Pages

Catalog excerpts

Torque QTL 210 series Parameter Winding type Peak torque @ 6°C/s increase Continuous torque Stall torque Ultimate current Ultimate torque @ 20°C/s increase Motor constant Motor torque constant Motortype max. voltage ph-ph Peak current Back EMF phase-phase peak Coil induction per phase Electrical time constant Coil resistance per phase Continuous power loss Thermal time constant Temperature cut-off / sensor Please check the T/n diagram in our manual or online simulation tool. Motor height Lamination stack height Rotor inertia 1. Actual values depend on bus voltage. mounting surface is at 20°C and the motor is driven at maximum continuous current. If these values differ in your application, please check our simulation tool or manual. 3.Rth based on radial mounting of stator 4022 363 0300 - Ver. 2.2 lamination stack. 2. These values are only applicable when the Stator mass excluding cables Rotor mass Total mass excluding cables Cable mass Cable type (power) Cable type (sens

Open the catalog to page 1

M4 `11 (32x) Mounting instructions and tolerances can be found in the torque installation manual. Manuals and 3D CAD files can be downloaded from our website. M4 `11 (32x) ©2022 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.

Open the catalog to page 2

QTL 210 Torque motors 2Pages

Catalog excerpts

All Tecnotion catalogs and technical brochures

QTL 210 Torque motors
2Pages