Magnetic Workholding
4Pages

{{requestButtons}}

Catalog excerpts

Magnetic Workholding - 1

MAGNETIC WORKHOLDING 800-543-4071 l Fax: 937-832-1274 l E-Mail: info@te-co.com l www.te-co.com 1

Open the catalog to page 1
Magnetic Workholding - 2

MAGNETIC WORKHOLDING MagVISE Electro-Permanent Magnetic Chucks MagVISE electro permanent chucks are used for normal and heavy duty drilling, milling, and boring operations on medium or large sized work pieces. Rough and uneven stock is no problem to hold - simply use the sliding pole extensions. Machine 5 sides easily! • Drastically reduces set up time while maintaining uniform electro permanent holding power over the entire work piece. • 5-sided machining and through-hole drilling in • No workpiece distortion. Tool chatter is minimized, and surface finish and tool life are improved. •...

Open the catalog to page 2
Magnetic Workholding - 3

MAGNETIC WORKHOLDING Application Worksheet A = Workpiece Contact Surface Area (X x Y) (mm) D = Cutting Tool Diameter (mm) F = Feed rate (mm/min) MSR = Maximum Stock Removal 1. Figure workpiece contact surface area: 2. Calculate Maximum Stock Removal: These values should be used as approximations based on testing. Actual results may be different due to workpiece material, contact area, and cutting parameters. TE-CO is not responsible for loss or damage associated with the use of this product. • Workpiece should cover at least 4 poles for maximum holding power. • Workpiece should be at least...

Open the catalog to page 3
Magnetic Workholding - 4

your free Master Catalog TE-CO 109 Quinter Farm Rd. Union, OH 45322 www.te-co.com www.toolexvises.com

Open the catalog to page 4

All TE-CO catalogs and technical brochures

  1. Plain Clamps

    1 Pages

  2. Hoist Rings

    22 Pages

  3. Toggle Clamps

    12 Pages

  4. Toolex Vises

    44 Pages

  5. 5-Axis Vise

    2 Pages

  6. Columns_Plates

    12 Pages

  7. Hoist ring

    22 Pages

  8. Toggle Clamp

    12 Pages