ZT5000
2Pages

Quality Inspection Systems High Speed Diameter Measurement and Lump/Neck-Down Gauge for Bare Wire and Fiber Images of Lump and Neck-Down Defects The High-Speed Lump and Neck-Down Inspector is the only tool that can provide images of your lumps and neck-downs on: Bare Wire and Fiber. This is critical in assessing whether a measured diameter variation is in fact a defect and whether action must be taken. Your technical staff won’t have to rewind miles of product to try to locate a defect. They can use Taymer’s image viewing software to analyze and diagnose any detected defects. Accurate, Multi Axis Diameter Measurement The High-Speed Lump and Neck-Down Inspector also provides you with very accurate, Multi-Axis diameter measurements. This diameter information can be integrated with other machinery in your line for complete automation of your line processes. The High-Speed Lump and Neck-Down Inspector’s display also makes it easy for engineering and production supervisors to examine the outer surface of your product as it is being extruded. Quality Assurance The High-Speed Lump and Neck-Down Inspector will capture images of your cable defects, save them to disk so you can print them out to include in your quality reporting both internally and to your customers. Defect locations are recorded together with the image of the defect allowing your operators to find and eliminate lumps and neck downs before they reach your customers or fail in the field. With Taymer’s High-Speed Lump and Neck-Down Inspector, you can be sure the product going to your customers meets your high standards. FEATURES Detects, bulges, neck-downs, lumps, on bare wires, fiber, and other small diameter products. Saves length information for each defect to allow operators to easily locate the defects after detection Diameter variations as small as 1µm can be identified System analyzes diameter for the full product length Supports line speeds up to 3000 meters per minute Utilizes intense LED backlighting to create sharply defined wire edges Alerts operator and production machinery if a defect is detected Generates a PDF report that contains diameter and defect information for the whole run Available in either 1 or 2 axis configur

SPECIFICATIONS Maximum Line Speed: Without stand: (Custom stands can be built) Exact max speed will depend on specific application Detectable Diameter Variation (+/-): 1µm (Exact dimension depends on application and Can be positioned anywhere in-line. Typically located on wire drawing line, draw tower or rewinding line camera configuration) Defect Length Along the Cable: Image Processing: At 3000 meters per minute, the minimum defect length that can be detected is 0.3 mm. Smaller defect lengths can be detected at lower speeds All images from all cameras are read, enhanced and analyzed,...