Assembly ERO Joint® HP (Hinge Pin)
3Pages

Assembly ERO Joint® HP (Hinge Pin) AT5 -T10 – AT10 – AT20 – H – 8M version Align the teeth. Teeth must be correctly aligned to avoid any cables damage during pin threading. Misalignment of teeth or the using of a nonchamfered pin can damage the belts cables during the installation 2 Begin to thread the pin by using an electric screwdriver and water (used as lubricant), to help the threading. For a correct alignment, use the plate/piece of belt furnished, like photo. OK Cables are in contact with the pin ; be careful to prevent any cables damages during the installation Check to correctly encase the joint’s teeth. 3

Then, grind the pins side which exceed. Check that the pin doesn’t exceed any edge of the belt. Don’t disassemble the belt (ask us in case). Respect the indications on the belt: ALIGN THE TEETH – CENTER THE PIN Make the mounting easier: If your machine doesn’t have a tensioning system, ask for the tensioning tool for ERO Joint® HP Belts. Possibility to mount the belt in 2 times, pins with head mounted in front of each other (locking pins); Contact us for more information! Discover the entire ERO Joint® range of solution: www.ero-jo

Troubleshooting Guide Possible cause Too high tensioning Joint breaking Solution Reduce the tension Incident or usury Bad pin insertion / Misalignment The photo shows a case where pin was not of joints teeth correctly inserted (cables are not damaged). Possible cause is a misalignment of the joint teeth. Read carefully the mounting documentation, and follow the instruction : Undamaged Cable Don’t disassemble the belt (ask us in case) Absence of lubricant Use water to help the insertion Misalignment of joints teeth Align correctly the joints teeth 5 place des Alliés – 68290 MASEVAUX – Tél....