AP-10 Sn63Pb37
2Pages

ELSOLD Solder Paste AP-10 Sn63Pb37 / Sn63Pb36Ag2 Solder Paste AP-10 has been designed as a no clean, air or nitrogen reflowable solder paste. This formula has a wider process window and shows better activity on OSP boards than previous no clean formulations. AP-10 is a solder paste that maintains its activity and printing characteristics for up to 8 hours without shear thinning. AP-10 can tolerate printing pauses of up to 60 minutes with an effective first print down to 0.5 mm. The residues from AP-10 are light amber and clear from solder balls. AP-10 flux residues are light amber and washable with alcohols and/or commercial cleaners. Very good wetting behaviour on most surfaces High printing speeds up to 120 mm/s High activity on all substrates Very long stencil life of more than 6 hours Suitable for BGA and pBGA ■ Very good tack time for up to 24 hours ■ J-STD-004 Flux classification: B0L1 ■ Very good printing characteristics down to 0.5 mm pitch with type 3 powder ■ Very good slump characteristic Surface Insulation Resistance J-STD-004, IPC-TM-650, Method 2.6.3.3 AP-10, uncleaned after 24 h: 9.6 x 108 Q Control board after 24 h: 1.1 x1010Q Control board after 96 h: 1.2x1010 Q Control board after 168 h: 1.2x1010 Q Physical Properties Data for SnPb(Ag) solders, 86 - 90 % metal, Powder type 3 (25 - 45 pm) Viscosity 500 - 800 Pa s_ Application Solder paste AP-10 can be applied by dispensing, stencil or sieve printing AP-10 is a no clean paste. Residues do not need to be removed in most cases, if cleaning is required solvents like ethanol, isopropanol or mixtures of alcohols and halogenated hydrocarbons as well as commercially available cleaners can be used for effective cleaning. TAMURA ELSOLD GmbH www.tamura-elsold.de HuttenstraKe 1 ■ D-38871 llsenburg Phone +49 (0)39452 4879-11 ■ Fax: -66 info@tamura-elsold.de

ELSOLD Solder Paste AP-10 Sn63Pb37 / Sn63Pb36Ag2 Cassettes: DEK PRO-FLOW™ Cassettes Syringes: 10ccand30cc Storage and Shelf Life Jars: up to 6 months Refrigerated storage at 6 — 16 °C is recommended for extended storage times. The material should be allowed to reach room temperature by itself before opening containers to avoid condensation of moisture on the cold material. Printing Squeegee: Stainless Steel Stencil/Sieve: Stainless Steel Environment: Recommended temperature range 20 - 25 °C, RH 40 - 65 % Topside Temperature of Board to be 205- 220 °C Liquidus Temperature for Sn62 & Sn63...