1. Catalogs
  2. Tamura Corporation
  3. Servo system current-output type S29S D24 series_S29SD24Z

Servo system current-output type S29S D24 series_S29SD24Z

Servo system current-output type S29S D24 series_S29SD24Z

Servo system current-output type S29S D24 series_S29SD24Z

Product catalog summary
Specifications:
The S29S D24 series is a current-output type servo system designed for use in general electronics applications. It operates at a rated current of 1000A with a maximum current capacity of ±2100A for 3 seconds. The measuring resistance varies with temperature and current, with specific values provided for ±15V and ±24V power supply conditions.

Output Characteristics:
The output current is 200mA with a conversion ratio of 1:5000, and the accuracy is within ±0.4%. The offset current is ≤±0.4mA, and the output linearity is ≤±0.1%. The power supply voltage ranges from ±15V to ±24V, and the consumption current is ≤±35mA.

Performance Parameters:
The response time is ≤1μs for a di/dt of 100A/μs. The thermal drift of gain is ≤±0.01%/°C, and the offset current thermal drift is ≤±0.5mA at -10℃ to +70℃ and ≤±0.8mA at -40℃ to +85℃. The hysteresis error is ≤±0.2mA.

Insulation and Temperature:
The insulation withstands AC4000V for 1 minute, and the insulation resistance is ≥500MΩ at DC500V. The operating temperature range is -40℃ to +85℃, and the storage temperature range is -40℃ to +90℃.

Design and Dimensions:
The product dimensions are specified with tolerances of ±0.5mm, and the weight is approximately 560g. Connectors are provided by Molex and JST, with specific part numbers listed.

Important Notices:
The document emphasizes that the product is not intended for use in critical applications such as medical devices or nuclear power control. Users are advised to ensure safety and reliability in their designs, especially in special environments or applications. The product is not designed to resist radiation, and the document may not be reproduced without permission from Tamura Corporation.
See more

Catalog excerpts

Servo system current-output type S29S D24 series_S29SD24Z-1

電流センサ関連 CURRENT SENSORS 磁気平衡式電流出力型 Servo system Current-output type 定格電流 Rated current 最大電流 3sec Maximum current 3sec ± 15V 測定抵抗   Measuring resistance 定格出力電流 Output current 出力電流精度 Output current accuracy 出力直線性 Output linearity 電源電圧 Power supply voltage 消費電流 Consumption current di/dt 応答速度 (@90% of If) di/dt response time 出力電流温度係数 Thermal drift of gain ヒステ シス誤差 リ Hysteresis error 絶縁耐圧 Insulation withstanding AC4000V,1 分間 ( 感応電流 0.5mA), 貫通部内側⇔端子一括間 AC4,000V, for 1minute(sensing current 0.5mA),inside of through hole ⇔ terminal 絶縁抵抗 Insulation resistance ≧ 500MΩ(at DC500V) 貫通部内側⇔端子一括間、inside of through hole ⇔ terminal 動作温度範囲 Ambient Operating temperature 保存温度範囲 Ambient storage temperature 2 次側コイル抵抗値    Secondary coil resistance オフセ ト電流温度係数 ッ Thermal drift of offset ※1 オフセ ト電流はコアヒステ シス除去後の値と ッ リ する。  ※ 1次導体の温度は100℃を超えない様に く さ ※UL承認条件につき しては、 して だ い。 ま 別紙を参照願います。 *1 Offset current value is after removal of core hysteresis. *Temperature of the primary conductor(busbar) should not exceed 100℃. *Please refer to the another sheet about conditions of UL Recognition.

 Open the catalog to page 1
Servo system current-output type S29S D24 series_S29SD24Z-2

電流センサ関連 CURRENT SENSORS 磁気平衡式電流出力型 Servo system Current-output type 端子番号 Terminal number ① ② ③ ④ NC (No connection) +Vcc (+24V) –Vcc (+24V) Iout メ ーカー Manufacturer Molex コネ クタ Connector 製品番号 旧製品番号 Part Number Old Part Number 39-28-8040 質量 Weight 560g typ 注 Note 1. 指示な き寸法公差は±0.5mm Unless otherwise specified, tolerances shall be ±0.5mm 2. 外形寸法の単位はmmと する。 Unit is [mm] 端子番号 Terminal number ① +Vcc (+24V) ② Iout ③ –Vcc (–24V) メ ーカー Manufacturer Molex コネ クタ Connector 製品番号 旧製品番号 Part Number Old Part Number 38-00-6293 質量 Weight 560g typ 注 Note 1. 指示な き寸法公差は±0.5mm Unless otherwise specified, tolerances...

 Open the catalog to page 2
Servo system current-output type S29S D24 series_S29SD24Z-3

電流センサ関連 CURRENT SENSORS ご注意 Important Notice 1. 本書の記載内容は、改良などにより予告なく変更することがありま す。 ご使用の際には、最新の情報であることをご確認下さい。 2. 本製品は一般的な電子機器家電製品、事務機器、情報機器、通信 端末機器、計測機器、産業機器などへの使用を意図しております。 極めて高度な品質及び信頼性が要求され、その製品の故障や誤動 作が人命・身体に危害を及ぼす機器、装置医療機器、輸送機器、 交通信号制御機器、火災・防犯装置、航空宇宙機器、原子力制御、 燃料制御、車載機器、各種安全装置などの特定用途に使用される ことを目的として設計及び製造されたものではございません。 本資料に個別に記載されている場合を除き、本特定用途に使用され た場合には、お客様または第三者の損害等について当社はいかな る責任も負いかねます。 3. 当社は品質、信頼性の向上に努めておりますが、電流センサはある 程度の確率で機能不具合、故障の発生は避けられません。故障の 結果として、人身事故、火災事故、社会的損傷などを発生させないよ う、使用者の責任において、装置やシステム上での十分な安全設計 と確認を行って下さい。 4. 本書に記載されている動作例および回路例は、使用上の参考として 示したもので、これらに起因する当社もしくは第三者の工業所有権、...

 Open the catalog to page 3

All Tamura Corporation catalogs and technical brochures

  1. S25PxxxD15*

    3  Pages

  2. S26P200D15Y

    3  Pages

  3. S29S1T0D24Z*

    4  Pages

  4. Current Sensors

    111  Pages

  5. L07PxxxS05

    2  Pages

  6. L07PxxxD15S

    2  Pages

  7. L07PxxxD15

    2  Pages

  8. F03PxxxS05

    8  Pages

  9. F01PxxxS05

    7  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.