Catalog excerpts
HOW TO REDUCE AUDIBLE NOISE Audible Frequency Range It is said 20Hz to 20KHZ. Power Supply Switching Frequency VS Noise Generation Efficiency is Key for high performance Power Supply. To achieve it, Switching method is being selected as for appropriate solution. The switching frequency is mostly like 30 to 150KHz, To improve efficiency more at low load it is used to apply load, “burst mode “ solution. The Burst mode frequency is within the audible frequency band, Power Supply would generate audible noise at low load condition like Stand by mode, and it is needed to minimize. Mostly the roots of the audible noise was created by Switching Transformer. And depends on that structure, the level of noise would be changed. Burst Mode Please check the answer on the other side!
Open the catalog to page 1Tamura Power Supply Module Series Tamura' s power supply modules (EPM, SPM, and BPM Series) achieved by using Tamura Original designed structure. * Patent applied for the structure Audible Noise is reduced to max 1/60 (in comparison to Tamura' s discrete power supply ). Performance Comparison TX of ordinal discrete power supply Tested in Tamura' s soundproof room Transformer inside EPM at the burst mode (Comparison with Tamura' s previous Power Module)
Open the catalog to page 2All Tamura Corporation catalogs and technical brochures
-
S25PxxxD15*
3 Pages
-
S26P200D15Y
3 Pages
-
S29S1T0D24Z*
4 Pages
-
Current Sensors
111 Pages
-
Nitrogen Gas Generator
1 Pages
-
L07PxxxS05
2 Pages
-
L07PxxxD15S
2 Pages
-
L07PxxxD15
2 Pages
-
F03PxxxS05
8 Pages
-
F01PxxxS05
7 Pages
-
Power Module Handbook
16 Pages
-
Power Module Application Note
19 Pages
-
Application note
19 Pages