Tamson Instruments Specification sheet Specifications TC16 - TC40 - TC58 Thermostatic Bath and Circulator Used inside bath: stainless steel 304, brass Ambient .. 250C/..482F Standard C, F on request Reading Setting Bath volume Completely stainless steel Precise control, auto tune Over temperature protection RS232 communication Standard bath drain Standard cooling coil General The TC16, TC40, and TC58 are used for precise temperature control. The baths offer a choice in different bath volumes and offer high reliability for use under rough circumstances. Depth bath * Optional pump with pressure max 1Bar, flow max 16L/min, reference: 24T0399. ** Additional heater 1400W optional to heat larger loads when circulating Accuracy The insulation of the bath and electronic design result in a stable working temperature of ± 0.02°C for the TC16, TC40, and TC58. The stability was measured in water at 50°C. The set point temperature can be set in steps of 0.1C in the range of 0C up to 250C (32°F..482F). The accuracy on the display is displayed in 0.1°C. However the controller has an internal accuracy of 0.01°C. This two decimal-readout also is available using the RS232 communication port and the free Tamcom software. Span The baths can be operated from ambient up to 250C (482F). Due to the "self-heating" of the stirring mechanism (friction-heat) and when using a top lid, the minimum temperature lies approximately 5C above the ambient temperature. When using the standard built-in cooling coil the minimum operating temperature lies approximately  5C above the temperature of the cooling liquid circulating inside the cooling coil. Minimum working temperature when using external cooling lies around 10°C. Lower temperatures generate problems with built up of condensate in the inner insulation of the bath. Safety The bath conforms to CE regulation. It is further equipped with a mechanical resettable safety thermostat. Temperature readout Standard available in C, on request in F. Pump Three pumps can be offered: - Standard pump - Suction/pressure pump - Performance pump Optional See table on the next page.

Tamson Instruments Specification sheet Specifications TC16 - TC40 - TC58 Thermostatic Bath and Circulator Operating 1 - LED Temperature display 2 - Item 3 - Sequence 4 - Up & Down 5 - Over temperature safety 6 - Power The thermostatic bath is easy to operate. The four keys will set all the parameters. Using the up and down arrow the desired working temperature or SP can be set in steps of 0.1°C. The bath temperature is displayed with a resolution of 0.1°C. Item Remote PT100 RS232 serial communication Software “Tamcom” Performance pump Bath drain TC40 On request 02T3025 Free of charge 24T0399...

Tamson Instruments Specification sheet Specifications TC16 - TC40 - TC58 Thermostatic Bath and Circulator Item Cooling circulator TLC10-3 230V/50Hz Cooling circulator TLC10-3 230V/60Hz Cooling circulator TLC10-3 115V/60Hz Cooling circulator TLC15-5 230V/50Hz Cooling circulator TLC15-5 230V/60Hz Cooling circulator TLC15-5 115V/60Hz