Push-in Fitting Diaphragm Valves

Product catalog summary

Overview: This document provides technical specifications and instructions for the Push-in Fitting Diaphragm Valve by Takasago Electric, Inc. It highlights the ease of connecting and disconnecting tubing, the valve's features, and its specifications.

Features:

Easy connection and disconnection of tubing without special preparation. Simply insert the tubing into the ports and pull out while pushing in the port ends (collet) for disconnection.
The tubing can revolve freely after insertion, preventing kinking and twisting.
Integral molding eliminates leakage concerns between fittings and the body.
Compatible with O.D. 2 mm PTFE/PFA tubing.
High chemical resistance due to PPS, FPM, and PTFE wetted materials.

Specifications:

Model Numbers: CTV-2-P2RF-S (2-way N.C.), CTV-3-P2RF-S (3-way).
Orifice Diameter: 1.2 mm.
Operating Pressure Range: -50 to 200 kPa.
Fluid Temperature Range: 5 to 50°C.
Ambient Temperature Range: 5 to 40°C.
Rated Voltage: 12 VDC, 24 VDC.
Power Consumption: 3.5 W.
Duty Cycle: Continuous.
Dielectric Strength: AC1500V for 60 seconds.
Wetted Materials: PPS, PTFE, FPM, and Al₂O₃ for CTV-3-P2RF-S.
Operating Pressure: 700 kPa at 20°C, 450 kPa at 100°C.
Maximum Fluid Temperature: 100°C.

Additional Information: The document includes a QR code and a link to a video demonstrating the connection process. It also notes that specifications may change without notification and advises consulting for other applicable models.

Catalog excerpts

SOLENOID VALVE Push-in Fitting Diaphragm Valve No separate fittings required Just insert tubing directly Just insert plastic tubing into the ports to connect the valve. No special preparation of the tubing is required, such as enlarging the connection end. For disconnection, simply pull out the tubing while pushing in the port ends (collet). The tubing can freely revolve even after insertion. This prevents troublesome kinking and twisting that can occur when you screw the other end of the tubing into a threaded port using a conventional fitting. Integral moulding eliminates the concern of leakage between the fittings and the body. Applicable to O.D. 2 mm PTFE/PFA tubing. High chemical resistance due to PPS, FPM and PTFE wetted materials. Just insert the tubing into ports. Just pull out the tubing while pushing in the port ends (collet). Use the QR code on the right or the link below to see the movie “How to connect?” www.takasago-elec.co.jp/movie/push-in_fitting.wmv TAKASAGO ELECTRIC, INC. 66 KAKITSUBATA, NARUMI-CHO, MIDORI-KU, NAGOYA, 458-8522 JAPAN Tel +81-52-891-2301 Fax+81-52-891-7386 E-mail: [email protected] URL: http://www.takasago-fluidics.com/

Open the catalog to page 1