STANDARD | OH-Type PTC has a unique heat property that allows the PTC heat output to be regulated by the airflow applied. The higher the airflow, the higher the heat output and power(wattage). Hence depending on the end design, if the ambient temperature is high, the PTC output power will decrease; if the airflow is high with low ambient temperature, then the PTC output power will increase. Wired Type No Terminals to TO Order (Specify Model Number) Length unit:mm Rated Max Max Inrush Power@Air Speed 6.4m/s Available Certificate Model No. ii, . L LI Voltage Voltage Current 20 0 Frames Special Lengths RAW MATERIALS HEALTH PRODUCTS METAL STAMPING CONTROLLERS Dimensions and specifications may be changed without prior notice.

HEATERS KLC Precision and Wellness 100 V-120 V TO Order (Specify Model Number) Notes on PTC Air Heater Specifications Tables • Models with “ ” symbol are standard models. The delivery time for these models is shorter, and more cost saving. • The Power(W) in the Specifications table is based on PTC air heaters with Single Insulation(S). Please refer to “Notes on Part Numbering” for the difference in Power(W) efficiency for different insulation type. • Customized wattage, length and specifications can also be designed for large quantities.

SPECIAL | DC Models DC type PTC Heaters is most suitable for use in electric car heaters or for constant battery discharge. Please refer to Standard Models Table for other available lengths. However, the Power(W) of DC air heaters will be 15-30% less than AC heaters. Current greater than 20A are not recommended. For large current (>20A) designs, please contact our sales representative for special designs and safety recommendations. (A=P(W) / V) High current(A) PTC Air Heaters (520A) will require individual wiring for each terminal. The maximum current load for each terminal wire set is 513A....