Manufacturer Certificated Product Specification Model: TTX070BHE-02 7.0″TFT Display Module (800*480) This module uses RoHS material Tailor Pixels Technology Co., Ltd. www.tailorpixels.com [email protected] Ph: 86-755-8821 2653 Contents in this document are subject to change without notice. No part of this document can be reproduced or transmitted by any means for any purpose without the written permission of Tailor Pixels Technology Co., Ltd.

TAILOR PIXELS TECHNOLOGY CO., LTD.

TAILOR PIXELS TECHNOLOGY CO., LTD. Issued Date First Release.

TAILOR PIXELS TECHNOLOGY CO., LTD. Feature Size Resolution Interface Connect type Color Depth Technology type Display Spec. Pixel pitch (mm) Pixel Configuration Display Mode Driver IC Surface Treatment Viewing Direction Gray Viewing Direction LCM (W x H x D) (mm) Active Area(mm) With /Without TSP Weight (g) LED Numbers Spec 7-inch 800(horizontal)*480(Vertical) 24-bit RGB Connector 16.7M a-Si 0.1926 x 0.1790 R.G.B. Vertical Stripe Normally White HC 12 O’clock 6 O’clock 164.9*100.0*3.5 154.08 x 85.92 Without RTP TBD 27 LEDs Note 1: Viewing direction follows the data measured by optics equipment....

TAILOR PIXELS TECHNOLOGY CO., LTD.

TAILOR PIXELS TECHNOLOGY CO., LTD. VLED+ VLEDGND VCOM DVDD Power for LED backlight (Anode) Power for LED backlight (Cathode) Power Ground Common voltage Power for Digital Circuit DE/SYNC mode select Note1 Data Enable Vertical sync signal Horizontal sync Signal Blue data (MSB) Blue data Blue data Blue data Blue data Blue data Blue data Note2 Blue data (LSB) Note2 Green data (MSB) Green data Green data Green data Green data Green data Green data Note2 Green data (LSB) Note2 Red Data (MSB) Note2 Red Data

TAILOR PIXELS TECHNOLOGY CO., LTD. Red Data Red Data Red Data Note2 Red Data (LSB) Note2 Power Ground Pixel clock Note3 Power Ground Left/right selection Note4/5 up/down selection Note4/5 Gate ON Voltage Gate OFF Voltage Power for Analog Circuit Global reset pin Note6 NO connection Common Voltage Dithering function Note7 Power Ground NO connection NO connection

TAILOR PIXELS TECHNOLOGY CO., LTD.

TAILOR PIXELS TECHNOLOGY CO., LTD. 5 Absolute Maximum Ratings

TAILOR PIXELS TECHNOLOGY CO., LTD. 6 Electrical Characteristics 6.1 Driving TFT LCD Panel

TAILOR PIXELS TECHNOLOGY CO., LTD.

TAILOR PIXELS TECHNOLOGY CO., LTD. 6.2.1 Recommended Timing Setting of TCON TCON (Embedded in Source IC) Input Timing (DCLK, HSD, VSD, ED)

TAILOR PIXELS TECHNOLOGY CO., LTD. 6.2.2 Driving Backlight Item Forward Current Forward Voltage Backlight Power consumption Note 1: Each LED: IF =20 mA, VF =3.2V. Note 2: Optical performance should be evaluated at Ta=25℃ only. Note 3: If LED is driven by high current, high ambient temperature & humidity condition. The life time of LED will be reduced. Operating life means brightness goes down to 50% initial brightness. Typical operating lifetime is estimated data.

TAILOR PIXELS TECHNOLOGY CO., LTD. 7 Optical Characteristics Items Viewing angles Contrast Ratio Response Time Chromaticity White Color Gamut Luminance Test Conditions: 1. IF= 20mA (one channel), the ambient temperature is 25°C. 2. The test systems refer to Note 1 and Note 2. Note 1: Definition of optical measurement system. The optical characteristics should be measured in the darkroom. After 5 minutes of operation, the optical properties are measured at the center point of the LCD screen. All input terminals LCD panel must be ground when measuring the center area of the panel. Note 2: Definition...

TAILOR PIXELS TECHNOLOGY CO., LTD. Viewing angle is measured at the center point of the LCD by CONOSCOPE (ergo-80). Note 3: Definition of contrast ratio Note 4: Definition of Response time The response time is defined as the LCD optical switching time interval between “White” state and “Black” state. Rise time (TON) is the time between photo detector output intensity changed from 90% to 10%. And fall time (TOFF) is the time between photo detector output intensity changed from 10% to 90% Note 5: Definition of color chromaticity (CIE1931) Color coordinates measured at center point of LCD.

TAILOR PIXELS TECHNOLOGY CO., LTD. Note 6: Definition of Luminance Uniformity Active area is divided into 9 measuring areas (Refer Fig. 2). Every measuring point is placed at the Center of each measuring area Luminance Uniformity (U) = Lmin/ Lmax X100% L-------Active area length W----- Active area width Fig. 2 Definition of uniformity Lmax: The measured maximum luminance of all measurement position. Lmin: The measured minimum luminance of all measurement position. Note 7: Definition of Luminance: Measure the luminance of white state at center point.

TAILOR PIXELS TECHNOLOGY CO., LTD. 8 Environmental / Reliability Tests No Test Item High Temperature Operation High Temperature Storage Low Temperature Storage High Temperature & Humidity Storage -30℃ 30 min ~ +80℃ 30 min Change time: 5min, 30 Cycle Thermal Shock (Non-operation) Electro Discharge (Operation) Vibration (Non-operation) Shock (Non-operation) Package Drop Test C=150pF, R=330 Ω, 5 points/panel Air:±8KV, 5 times; Contact: ±4KV, 5 times; (Environment: 15℃ ~ 35℃, 30% ~ 60%, 86Kpa ~ 106Kpa) Frequency range: 10~55Hz, Stroke: 1.mm Sweep: 10Hz~55Hz~10Hz 2 hours for each direction of X.Y....

TAILOR PIXELS TECHNOLOGY CO., LTD. 9 Precautions For Use of LCD modules 9.1 Handling Precautions 9.1.1 The display panel is made of glass. Do not subject it to a mechanical shock by dropping it from a high place, etc. 9.1.2 If the display panel is damaged and the liquid crystal substance inside it leaks out, be sure not to get any in your mouth, if the substance comes into contact with your skin or clothes, promptly wash it off using soap and water. 9.1.3 Do not apply excessive force to the display surface or the adjoining areas since this may cause the color tone to vary. 9.1.4 The polarizer...