Simulate, Stimulate, Test.. MODELS 9100/9200300Vp-p Single / Dual Channel Signal Amplifiers • High voltage output to 300Vp-p (±150V) • Output current to 150mA (9200: 100mA per channel) • Full power bandwidth from DC to >500kHz Signal Ground Model 9100/9200 is a Single/Dual Channel, 2U, half-rack size, bench-top power amplifier designed for signal amplification. With unprecedented signal purity, Model 9100/9200 amplifies signals from DC to over 500kHz. The unit has a fixed gain of x15 however the same amplifier is available with custom gain and no signal purity or performance degradation whatsoever. Solves Common Problems Model 9100/9200 operates as an amplifying buffer for signals emitted from waveform, function, or pulse generators. Most of these generators produce signals limited to 20Vp-p into high impedance. Model 9100/9200 can convert these voltages to levels as high as 300Vp-p. The amplifier has a current driving capability of ±150mA (9200: ±100mA per channel) from a 0.1W source. While the output can drive small capacitive or inductive loads, for full high speed potential it is recommended that the load characteristics should be mainly resistive. Model 9100/9200 can withstand load capacitance and inductance up to 100pF and 0.5mH without any performance deterioration Ground Level The advanced power amplifier is supplied with floating input and output connectors allowing flotation from ground level up to 250VDC. The only limitation is that both the input and output grounds must connect to the same level. This capability is extremely important in applications where the amplifying device must reside on the same ground level as its source. The floating capability can be added or removed using a simple, user-accessible, jumper connection. Target Applications The amplifier case was designed to stack on top or below other Tabor products. It can also be mounted alongside a Tabor generator in a standard 19” rack. The waveform-amplifier combo is an ideal solution for virtually any high-voltage, wide bandwidth application. Cost Effective Solution Model 9100/9200 power amplifier is yet another of Tabor's cost-effective solutions for a full range of high voltage applications. For more information or to schedule a demo call today Or visit our website www.taborelec.com

Simulate, Stimulate, Test.. MODELS 9100/9200300Vp-p Single / Dual Channel Signal AmplifiersSpecification CONFIGURATION ORDERING INFORMATION Front panel BNCs 1M , DC coupled 50Vp-p DC to 500kHz Humidity: Safety: Calibration: Warranty (t): Signal Ground: INPUT CHARACTERISTICS No. of channels: Connector: Impedance: Damage Level: Frequency Range: OUTPUT CHARACTERISTICS Connector: Front panel BNCs Protection: Short-circuit, 10 seconds Polarity: Normal Frequency Range: 47Hz to 63Hz Power Consumption: 60W Signal Ground: Floated to the same level With Feet 315 x 102 x 395 mm (WxHxD) Without Feet 315...