Catalog excerpts
TSQS-CW1HG-10LC Optical Transceiver QSFP28 CWDM4 10km Transceiver, With Diagnostic Monitoring Optical link budget: Supports 6.5 dB of link budget Link budget assumes the use of KR4 FEC by the host Uncooled CWDM DFB lasers, directly modulated Electrical interface: retimed CAUI-4 per 100G Ethernet IEEE 802.3bm Annex 83E User controllable Transmit Input Equalization and Receiver Output Amplitude MSA-compliant performance monitoring via I2C interface Fiber connector: SMF LC duplex connector RoHS6 compliant (lead free) Description The QSFP28 100G-CWDM4-10km module is a highly integrated 4x28G transceiver focused on reach, bandwidth, density and cost for high port-count 100G systems, and client-side 100G interfaces. It is compliant with the 100G 4WDM-10 MSA, which is based on the CWDM4 MSA version 1.1, but alters some of the specifications to extend the link reach from 2 km to 10 km. It is interoperable with CWDM4 transceivers over a 2 km reach. Information and specifications are subject to change without notice. Please visit www.china-tscom.com for more information 8 Jinxiu Middle Road, Pingshan, Shenzhen, Guangdong, 518118, P. R. China +86 755 32983688 |info@china-tsc
Open the catalog to page 1OPTICAL TRANSMITTER PERFORMANCE Parameter Side Mode Suppression Ratio Average launch power, each lane Transmitter Reflectance Extinction Ratio Transmitter eye mask definition {X1, X2, X3, Y1, Y2, Y3} Average launch power of OFF transmitter, each lane Optical return loss tolerance Damage threshold, each lane Average receive power, each lane Unstressed Sensitivity (OMA) at 5 x 105 BER Stressed Sensitivity (OMA) Receiver Reflectance Center Wavelength Optical Modulation Amplitude (each lane) Launch power in OMA minus TDP, each lane Transmission & dispersion penalty, each lane RIN20 OMA OPTICAL...
Open the catalog to page 2Recommended operating environment Recommended Operating Environment specifies parameters for which the electrical and optical characteristics hold unless otherwise noted. Parameter Power Supply Voltage Operating Case Temperature GND Tx2n Tx2p GND Tx4n Tx4p GND ModSelL ResetL Vcc Rx SCL SDA GND Rx3p Rx3n GND Rx1p Rx1n GND GND Rx2n Rx2p GND Rx4n Rx4p GND ModPrsL IntL Vcc Tx Vcc1 Ground Transmitter Inverted Data Input Transmitter Non-Inverted Data Input Ground Transmitter Inverted Data Input Transmitter Non-Inverted Data Input Ground Module Select Module Reset +3.3 V Power supply receiver...
Open the catalog to page 34/4 Low Power Mode Ground Transmitter Non-Inverted Data Input Transmitter Inverted Data Input Ground Transmitter Non-Inverted Data Input Transmitter Inverted Data Input Ground Ordering information Part Number Product Description Important Notice Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by T&S before they become applicable to any particular order or contract. In accordance with the T&S policy of continuous improvement specifications may change without notice. The publication of information in...
Open the catalog to page 4All T&S Communications catalogs and technical brochures
-
Fiber Optical Components
22 Pages
-
S03 FGB Strain Sensor
1 Pages
-
T04 FGB Temperature Sensor
1 Pages
-
P02 FGB Pressure Sensor
1 Pages
-
FGB ID Reflector
2 Pages
-
56g QSFP AOC
4 Pages
-
40g QSFP Breakout AOC
6 Pages
-
40g QSFP AOC
4 Pages
-
10g SFP AOC
4 Pages
-
DAC Series
2 Pages
-
Fiber Optic Component II
12 Pages
-
Fiber Optic Component I
22 Pages
-
fiber optic
20 Pages
-
SFP28 Active Optical Cables
4 Pages