Apacer Industrial CF
20Pages

{{requestButtons}}

Catalog excerpts

Apacer Industrial CF - 1

CompactFlash Series 5 Specifications for Industrial CompactFlash Card August 7th, 2013 Version 1.2 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 www.apacer.com

Open the catalog to page ১
Apacer Industrial CF - 2

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA Features: CompactFlash Association Specification Revision 4.1 Standard Interface – 512 bytes per sector – ATA command set compatible – ATA transfer mode supports: PIO Mode 6 Multiword DMA Mode 4 Ultra DMA Mode 5 PCMCIA UDMA Mode 5 – Intelligent ATA/IDE module Wear-leveling algorithms to substantially increase longevity of flash media – Built-in BCH ECC capable of correcting up to 24 bits in 1,024 byte data – Flash block management – Power failure management – Supports S.M.A.R.T commands Connector Type 50 pins female Power consumption (typical)*...

Open the catalog to page ২
Apacer Industrial CF - 3

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA

Open the catalog to page ৩
Apacer Industrial CF - 4

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 1. General Description Apacer’s value-added Industrial CompactFlash Card offers high performance, high reliability and powerefficient storage. Regarding standard compliance, this CompactFlash Card complies with CompactFlash specification revision 4.1, supporting transfer modes up to Programmed Input Output (PIO) Mode 6, Multiword Direct Memory Access (DMA) Mode 4, Ultra DMA Mode 5, and PCMCIA Ultra DMA Mode 5. Apacer’s value-added CFC provides complete PCMCIA – ATA functionality and compatibility. Apacer ‘s CompactFlash technology is designed for...

Open the catalog to page ৪
Apacer Industrial CF - 5

Compact Flash 5 series 1.1.5 Power Failure Management Power Failure Management plays a crucial role when experiencing unstable power supply. Power disruption may occur when users are storing data into the SSD. In this urgent situation, the controller would run multiple write-to-flash cycles to store the metadata for later block rebuilding. This urgent operation requires about several milliseconds to get it done. At the next power up, the firmware will perform a status tracking to retrieve the mapping table and resume previously programmed NAND blocks to check if there is any incompleteness...

Open the catalog to page ৫
Apacer Industrial CF - 6

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA

Open the catalog to page ৬
Apacer Industrial CF - 7

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA Memory card mode Signal name #WAIT #INPACK #REG BVD2 BVD1 D8 D9 D10 GND I/O card mode Signal name #WAIT #INPACK #REG #SPKR #STSCHG D8 D9 D10 GND True IDE mode Signal name IORDY 2 DMARQ 2 DMACK #DASP #PDIAG D8 D9 D10 GND The signal should be grounded by the host. Connection required when UDMA is in use.

Open the catalog to page ৭
Apacer Industrial CF - 8

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 4. Product Specifications 4.1 Capacity Capacity specification of the Compact Flash Card series (CFC) is available as shown in Table 4-1. It lists the specific capacity and the default numbers of heads, sectors and cylinders for each product line. Table 4-1: Capacity specifications Capacity Total bytes Notes: Display of total bytes varies from operating systems. Cylinders, heads or sectors are not applicable for these capacities. Only LBA addressing applies Notes: 1 GB = 1,000,000,000 bytes; 1 sector = 512 bytes. LBA count addressed in the table...

Open the catalog to page ৮
Apacer Industrial CF - 9

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 4.3 Environmental Specifications Environmental specification of the Compact Flash Card series (CFC) which follows the MIL-STD-810F standards is available as shown in Table 4-3. Table 4-3: Environmental specifications Environment Specification Operation Vibration (Non-Operation) Shock (Non-Operation) Sine wave : 10~2000Hz, 15G (X, Y, Z axes) Half sine wave 1,500G (X, Y, Z ; All 6 axes) 4.4 Certification & Compliance The CompactFlash card complies with the following global standards: CE FCC Halogen-free CompactFlash Association Specification...

Open the catalog to page ৯
Apacer Industrial CF - 10

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 5. Software Interface 5.1 CF-ATA Command Set Table 5-1: CFC-ATA command set Command

Open the catalog to page ১০
Apacer Industrial CF - 11

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 6. Electrical Specification Caution: Absolute Maximum Stress Ratings – Applied conditions greater than those listed under “Absolute Maximum Stress Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these conditions or conditions greater than those defined in the operational sections of this data sheet is not implied. Exposure to absolute maximum stress rating conditions may affect device reliability. Table 6-1: Operating range Standard Operating Temperature Extended Operating...

Open the catalog to page ১১
Apacer Industrial CF - 12

Compact Flash 5 series FIGURE 7-1: Physical dimension

Open the catalog to page ১২
Apacer Industrial CF - 13

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 7.2 Write Protect by Hardware Switch This industrial CompactFlash comes with write protect function enabled by a hardware mechanical switch. Users can activate/deactivate the write protection with it. Please refer to the illustration below for locating the switch. Description of Apacer Write Protect: Apacer implements the Virtual Write scheme that allows write commands to go through the flash controller and data temporarily stored. The OS can still function normally but since the whole process is virtual, no data has been actually written into...

Open the catalog to page ১৩
Apacer Industrial CF - 14

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 8. Product Ordering Information 8.1 Product Code Designations A P – CF x x x x K X X S – XXXXXX A Firmware version Specification RM: Removable NR: Non-Removable ET: Extended Temperature NDRM: Non-DMA + Removable NDNR: Non-DMA + Non-Removable ETRM: Ext. Temp. + Removable ETNR: Ext. Temp. + Non-Removable ETNDRM: Ext. Temp + Non-DMA + Removable ETNDNR: Ext. Temp + Non-DMA + Non-Removable Halogen Free Compliant Configuration F Dual Channel N : Standard CTL Type 7: CTL BGA Package 9: CTL TSOP Package Model Name Apacer Product Code 13 © 2013 Apacer...

Open the catalog to page ১৪
Apacer Industrial CF - 15

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 8.2 Valid Combinations 8.2.1 Standard Temperature 8.2.1.1 Non-Removable Capacity

Open the catalog to page ১৫
Apacer Industrial CF - 16

Compact Flash 5 series AP-CFxxxxKXXS-XXXXXXA 8.2.1.3 Non-DMA + Removable Capacity 8.2.1.4 Non-DMA + Non-Removable Capacity Note: Please consult with Apacer sales representatives for availabilities.

Open the catalog to page ১৬

All Syslogic GmbH catalogs and technical brochures

  1. IPC/WLB-P

    2 Pages

  2. CPN/ANTWLPT-1A

    16 Pages

  3. CPN/ANTGPS-1A

    14 Pages

  4. TFT/PVxxxPU

    2 Pages

  5. REC/COMPACT8

    2 Pages

  6. DS_SIC4

    1 Pages

  7. DS_NETSBC71

    2 Pages

  8. DS_NETIPC_4

    2 Pages

  9. DS_NETIPC_6

    2 Pages

  10. IPC/NETARM-1

    2 Pages

  11. CEM/ATOME6

    2 Pages

  12. TFT/HOxxxPU7

    2 Pages

  13. IPC/WLB-xxxx

    2 Pages

  14. IPC/LEANBOX

    2 Pages

  15. TFT/PBxxxPU

    2 Pages

  16. IPC/SIC4

    1 Pages

  17. IPC/DIO32

    1 Pages

  18. IPC/NETIPC-4

    2 Pages

  19. IPC/NETIPC-6

    2 Pages

  20. TFT/PANxxxIS

    2 Pages

  21. IPC/NETSBC71

    2 Pages

  22. DS_WLB_v0.1

    2 Pages