anifold Nozzles, Threaded * molding solutions

06 Series 06 E Cut-out in mold plate for nozzle and connections Nozzle length Illustrations simplified, schematically drawn and not to scale. Values of the dimension L can be found in the data sheet on page 2. only required if B<15 àelectrical power àthermocouple Verteiler Oberfläche Depending on the selected nozzle type, different cut-outs are required for the nozzle tip. a) Through bore nozzle tip (K,Y) b) Blind bore nozzle tip (W) Dt Tip Ø H Gate orifice Ø The dimensions of the cut-out for the nozzle tip used can be found on the tip cut-out sheet on page 3. 2013-04-30 Errors and exceptions...

06 Series 06 E Manifold nozzles, screw fit Illustrations simplified, schematically drawn and not to scale. Product Type Different gate options can be implemented. see table at right. Hot runner nozzles in the 06 E01 range; è Nozzle size 06: Flow bore-Ø 6 mm è Nozzle style E: Manifold nozzle, Threaded Application For all usual thermoplastics Max. shot weight per nozzle (g) è 120 (open, low viscosity) è 80 (valve gate, low viscosity) Heating è externally heated, 230 V AC è changeable heater & thermocouple è 1 zone, 180...230 W è Fe/CuNi thermocouple, DIN EN 60584 Flow bore Ø Nozzle length Tip Extension...

06 Series 06 E Cut-out in Mould Plate for Nozzle Tips Illustrations simplified, schematically drawn and not to scale. à Cooling required around the nozzle tip, opposite to the nozzle tip à The front of the nozzle tip must always be against plastic. ±0,05 Reference notes 1, 3 2013-04-30 Errors and exceptions excepted. For a specific application, please consult Synventive. General tolerances according to DIN ISO 2768-mK 1. At the area of the nozzle gate replaceable, hardened (52 +2/-1 HRC) inserts are recommended by Synventive 2. Radius/chamfer at the front of the valve pin shall not be removed...

Information contained in this catalog is intended for Synventive customer use only. All rights reserved. Errors and omissions excepted. molding solutions