Firestar i401
2Pages

Firestar i401 Data Sheet The new Firestar i401 laser provides 400 watts of near-perfect beam quality from a single tube. Built around a hybrid waveguide/unstable resonator design, the i401 is driven by four field-replaceable integrated RF modules resulting in a rise time of less than 100 µs. Internal beam conditioning before the output aperture first conditions, collimates, and then rotates the linear beam polarization 45° as an aid in applications where a circular polarizer is used. The i401 operates at duty cycles ranging from < 10% all the way up to 100% (full CW operation). With a best-in-class energy efficiency, up to 23% better than other 400 W lasers, the i401 offers immediate savings on energy costs and its single tube design means the i401 weighs 24% less than competing lasers—an important consideration when mounting the laser on moving gantries or robotic motion systems. Other important design features include a pre-aligned output beam (centered in the aperture within ± 1.0 mm), an internal electromechanical shutter for maximum operator safety when integrated into the user’s control system, a TCP/IP web-based Internet interface for monitoring operating parameters, an internal humidity sensor that allows you to monitor relative humidity levels to prevent condensation damage and a built-in gas purge port for ease of connection to a nitrogen or instrument-grade air purge system. Invisible Laser Radiation Avoid eye or skin exposure to direct or scattered radiation Class 4 Laser Product Firestar i401 specifications* Output Specifications Cooling Specifications Environmental Specifications Physical Specifications Specifications subject to change without notice. Typical. Actual wavelength range may vary from 10.2–10.8 µm. This power level is guaranteed for 12 months regardless of operating hours. 48 VDC input voltage to obtain guaranteed output power. Measured from cold start with tube at 20 °C for 30 minutes at start running 99% duty cycle with 4 GPM flow and 20 °C coolant temperature. After two minutes (typ) at 99% duty cycle, 4 GPM flow, and 20 °C coolant temperature. Measured at 5 kHz, 99% duty cycle, 20 °C coolant temp, 30 minute warm-up. Measured at beam waist (see Final Test Report for beam waist location). Measured at 100 Hz, 10% duty cycle. Measured at 48 VDC input, 100% duty cycle. Firestar i401 lasers can operate at coolant temperatures up to 28 °C to reduce problems associated with condensation; however, this may result in decreased laser performance and/or reduced laser lifetime. Published specifications guaranteed at a cooling temperature of 20 °C. SYNRAD, Inc. 4600 Campus Place Mukilteo, WA 98275 tel 425.349.3500 fax 425.349.3667 email synrad@synrad.com

THIS MOUNTING HOLE PATTERN USED FOR BOTTOM ACCESS FASTENING. D 6X 8-32 UNC-2B .20 ACCESSORY MOUNTING HOLES BEAM CENTERED IN APERTURE WITHIN ±1.0mm D WATER OUTLET (1/2" TUBE FITTING) PART NUMBER: . FINISH CLASS: INTERLOCK (GRN/RED) TEMP (GRN/RED) SHUTTER (BLUE) WATER INLET (1/2" TUBE FITTING) 48V POWER TERM. (M10X1.5) SYNRAD INC. 4600 Campus Place Mukilteo, WA 98275 Phone: (425)349-3500 Fax: (425)349-3667 DWG/FILE NUMBER: PROPRIETARY THIS DRAWING IS PROPRIETARY TO SYNRAD INC. AND SHALL NOT BE USED OR DISCLOSED IN WHOLE OR IN PART WITHOUT WRITTEN PERMISSION OF SYNRAD INC. UNITS: Inches ADD...