Description Name The GP4 Unit Module is designed as a universal valve controller for earth-moving machinery. It features functions for controlling up to four bidirectional hydraulic valves and contains signal I/O for handling commonly used sensor signals and can also interact with other CAN-bus-connected modules. It also features 3D angle sensing for indication of e.g. bucket angles. Technical data Place the GP4 unit module on a flat surface in the tilting part of the unit with a unit connector to the left seen from the cab and with the logotype upwards. Use four M5 screws for the attachment. Make sure that the cables are routed so that there is minimal risk for wear and tear. Cables mounted together with hydraulic lines should be dimensioned and adapted for that environment. A Make sure the unit is safely positioned so that risks for impact injuries to the operator are eliminated. Also make sure screws of correct lengths are used so they do not protrude and consequently lead to lacerations.

Unit Connector Supply Connector Unit Connector (jst wpz 36-way) Digital pulse signal inputs. Active high signals (PNP) required. Can be configured as either analog voltage or analog current inputs. Current-regulated high-side outputs, max. current 2.75 A. Designed for proportional control of inductive loads. A and B ports used for bidirectional valves. Protected for over-current conditions. Open load detection. Coupler output High- and low-side switches, max. current 2.5 A. Designed for switching the inductive solenoid for the quick coupler function. Protected for over-current conditions. Open...