MACS Cab Module

Product catalog summary

Description: The GP1 Cab Module serves as a universal central controller for earth-moving machinery, capable of controlling hydraulic valves and connecting to low power CAN-bus units like joysticks and displays via three M8 connectors.

Technical Data:

Nominal Voltage: 12 and 24 V
Supply Voltage Range: 8 to 36 V
Electromagnetic Compatibility: ISO 13766:2006
Operating Temperature: -40 to +70 °C
Storage Temperature: -40 to +85 °C
Case Material: PA6 30GF
Weight: 220 g
Degree of Protection: Min. IP 50 with assembled mating connectors
CAN Termination Resistance: 600 Ω
Current Consumption: Standby up to 170 mA (12 V), 80 mA (24 V); Max. load 10 A
External Fuse: Max. 10 A

Analog Inputs:

Permissible Range: Full supply range
Measuring Range: 0 to 5 V
Resolution: 10 Bit

Digital Inputs:

Permissible Range: Full supply range
Input Type: Configurable for active high and low signals

Mounting Instructions: Install inside the cabin on a flat surface with visible LED indicators. Use mounting plates if drilling is not allowed. Ensure safe positioning to avoid operator injuries.

Connections:

Supply Connector: Tyco JPT2.8 6-way, with divided voltage supply circuit
Valve Connector: Tyco JPT2.8 9-way, with current-regulated high-side outputs
M8 Connectors: Standard M8 4-way female, for low consumption units
I/O Connector: Tyco Multi-Lock 040 16-way, with digital and analog inputs/outputs

Outputs:

Outputs 1 to 2: Current-regulated high-side outputs for inductive loads
Outputs 3 to 4: High-side switch for inductive loads
Output LED1 to LED3: Digital 5 V high-side switches, configurable as PWM outputs
Output BUZZER: PWM switched 5V high-side output for buzzers or LEDs

Analog Inputs: Used for dual signal input, forming axis 5.

+5 V Output: Current-limited for sensors and potentiometers, max. 140 mA.

Catalog excerpts

Place the unit inside the cabin on a flat surface. Make sure that the LED indicators are visible for maintenance. Use the attachment mounting plate if drilled holes or screws are not permitted on the safety cage. When mounting on the plate, self-tapping screws are preferred. When mounting on plastic panels, body washers and screws are recommended (M6). Make sure the unit is safely positioned so that risks for impact injuries to the operator are eliminated. Also make sure that screws of correct lengths are used so they do not protrude and consequently lead to lacerations. Strain relief the wiring harnesses if necessary.

Open the catalog to page 1

Supply Connector (Tyco JPT2.8 6-way) Not current limited, internally connected to supply input. Used for supplying external low consumption units, e.g. joystick handles or a display unit. CAN-bus-connected units must use the same GND reference. SVAB Hydarulik AB - Ulvsattersgatan 2 - SE 694 91 Hallsbeig - SWEDEN - +46 582 152 30 - www.svab.se © 2016 SVAB Hydraulik AB. All rights reserved. SVAB accepts no responsibility for possible errors in catalogs, brochures and other printed material. SVAB reserves the right to alter its products without prior notice. This also applies to products already...

Open the catalog to page 2

MACS Cab Module

MACS Cab Module

Catalog excerpts

All SVAB Hydraulik AB catalogs and technical brochures