Product features 1.. Four process water cooling 2. Square cast iron cover 3. Small volume and large heat exchange area 4. Save water content The oil side Maximum operating pressure 20bar Maximum operating temperature 100°C

Hts-m Series selection curve (4 channels) The curve is based on the following conditions Oil ISO VG32 The inlet temperature of oil is 60°C The inlet temperature of water is 32°C Oil water ratio 3:1 Structure 4 channel Oil pressure loss = 0.1 Mpa (1 bar) = 0.15 Mpa (1.5 bar) Water pressure loss 0.01Mpa-0.1mpa (0.1bar) The flow of water Minimum flow (L/Min) Maximum flow (L/Min) HST - M - 3 5 to 35 HST - M - 4 20, 65 HST - M - 5 25, 90 HST - M - June 25, 100 HST - M - 8 to 30, 170

Product selection steps 1. Please select the flow rate (L/min) and Heat exchange (KCZL/HR) select the appropriate model 2. Beyond the use conditions of the model catalog or hope to get more detailed To select the technical data, simply fill out the product selection specification form on the next page After the necessary matters by fax or email to my company, I The company will try to select the results in the shortest possible time Precautions for Use warning 1. In order to use this product more safely, please read it carefully before use Operation manual, and confirm matters needing attention...

4. Use cooling water The cooling water of our standard oil cooler is usually tap water Groundwater, industrial water and comply with the water quality standards in the table below, do not use polluted water Disclaimer/Precautions Failure to comply with this content will exclude you from warranty. 1. Use Do not use for any purpose other than oil cooler [Cases that cannot be used] The heater Use non-oil fluids (air, gas, etc.) 2. Use fluids Do not use fluids other than ordinary mineral oil Consult the technical development department if you want to use fluids other than those specified 3. Use pressure...