HLG-100H Series
4Pages

HLG-100H Series 100W IP67 Constant Voltage LED Lighting Power Supplies Features • • • • • • Constant voltage mode power supply Universal AC input up to 305VAC IP67 level Built in active PFC function Constant current level adjustable through output cable Short circuit, over current, over voltage, over temperature protections • Compliance to worldwide safety regulations for lighting Specification Voltage Power Factor INPUT PF>0.98/115VAC, PF>0.95/230VAC, PF>0.93/277VAC at full load (Please refer to Power Factor Characteristic curve) Inrush Current Leakage Current Rated Current Ripple & Noise Over Voltage Shutdown and latch off output voltage, re-power on to recover PROTECTION Short Circuit Constant current limiting, recovers automatically after fault condition is removed Over Temperature 100℃ ±10℃ (RTH2); shutdown output voltage, recovers automatically after temperature goes down Over Current 95~106% rated output current; constant current limiting, recovers automatically after fault condition is removed Rise Time 16ms@230VAC & 115VAC, full load condition ±1.0% Line Regulation ELEC. CHAR. Voltage Tolerance Load Regulation Setup Time 10~500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes Withstand Voltage SAFETY Operating: 20%~95% RH; Storage: 10%~95% RH (non condensing) Temp. Coefficient Isolation Resistance I/P-O/P, I/P-FG, O/P-FG:>100M Ohms / 500VDC / 25℃/ 70% RH Safety Standard Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C (>60% load) ; EN61000-3-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria A M.T.B.F. OTHERS 1 All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature 2 Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor 3 Tolerance: includes set up tolerance, line regulation and load regulation 4 Derating may be needed under low input voltages. Please check static characteristics for more details 5 Voltage Adjustment Range is only applicable for type A 6 Safety and EMC design refer to EN60598-1, CNS263, GB7000.2, FCC part 18 7 Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time 8 The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC directive on the complete installation again Sunpower Technology LLP Orion House, Calleva Park, Aldermaston, Berkshire RG7 8SN Tel: +44 (0)118 981 1001 • E-mail: sales@sunpower-uk.com

HLG-100H Series 100W IP67 Constant Voltage LED Lighting Power Supplies Block Diagram Fosc: 100KHz EMI FILTER & RECTIFIERS RECTIFIERS & FILTER POWER SWITCHING De-Rating Curve FG Green/Yellow AC/L(Brown) AC/N(Blue) T Case: Max. Case Temperature Sunpower Technology LLP Orion House, Calleva Park, Aldermaston, Berkshire RG7 8SN Tel: +44 (0)118 981 1001 • E-mail: sales@sunpower-uk.com

HLG-100H Series 100W IP67 Constant Voltage LED Lighting Power Supplies Driving Methods of LED Module 100 Constant V oltage area There are two main kinds of LED driver method “direct drive” and “with LED driver”. A typical LED power supply may either work in constant voltage mode (CV) or constant current mode (CC) to drive the LEDs. (B) Constant Current area Our LED power supply with CV+CC characteristics can be operated at both CV mode and CC mode as this diagram shows. Power Factor Characteristics Efficiency vs Load (48V Model) 96 Constant Current Mode Waterproof Connection M12 Order No....

HLG-100H Series 100W IP67 Constant Voltage LED Lighting Power Supplies Optional Junction Box 10 5 FG (Green/Yellow) AC/L(Brown) AC/N(Blue) SJTW 18AWG x 3C +V(Red) -V(Black) SJTW 14AWG x 2C 2- 5 Sunpower Technology LLP Orion House, Calleva Park, Aldermaston, Berkshire RG7 8SN Tel: +44 (0)118 981 1001 • E-mail: sales@sunpower-uk.com