CLG-100 Series
3Pages

CLG-100 Series 100W IP67 Constant Voltage LED Lighting Power Supplies Features • • • • • • • • • Universal AC input up to 295VAC High efficiency up to 90% IP67 level for indoor and outdoor applications Built in active PFC function Short circuit, over current, over voltage, over temperature protections Cooling by free air convection High reliability Compliance to worldwide safety regulations for lighting Suitable for dry, damp, wet locations Specification Voltage INPUT Inrush Current Leakage Current Power Factor PF>0.95/115VAC, PF>0.95/230VAC, PF>0.92/277VAC at full load (Please refer to Power Factor Characteristics curve) Voltage Adj. Range Constant Current Operation OUTPUT Fixed. Can be modified between 0%~-15% rated output voltage 9 ~ 12V Rated Current Current Adj, Range Power Fixed. Can be modified between 3%~-25% rated output current 60W Voltage Tolerance Ripple & Noise Over Voltage Shutdown and latch off output voltage, re-power on to recover PROTECTION Short Circuit Hiccup mode, recovers automatically after fault condition is removed Over Temperature 90℃ ±10℃ (RTH2); shutdown output voltage, re-power on to recover Over Current 95~102%; constant current limiting, recovers automatically after fault condition is removed Line Regulation Setup, Rise Time Holdup Time ELEC. CHAR. Load Regulation Operating: -30~+70℃ ; De-rating: 50~70℃@60% load ; Storage: -40~ +80℃ 10~500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes Withstand Voltage Isolation Resistance Safety Standard Operating: 20%~95% RH; Storage: 10%~95% RH (non condensing) Temp. Coefficient Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C (>75% load) ; EN61000-3-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria A M.T.B.F. OTHERS 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. This is the maximum possible output current and power, over load protection may be activated slightly below this level to comply with the requirementof UL1310 class 2. 6. 3 years warranty is guaranteed for operating ambient temperature no higher than 68. 7. Constant current operation region is within 65% ~ 100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for specific system design. 8. The power supply is considered a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation. 9. Safety and EMC design refer to EN60598-1, subject 8750(UL), CNS15233, GB7000.1, FCC part18. Sunpower Technology LLP Orion House, Calleva Park, Aldermaston, Berkshire RG7 8SN Tel: +44 (0)118 981 1001 • E-mail: sales@sunpower-uk.com

CLG-100 Series 100W IP67 Constant Voltage LED Lighting Power Supplies Block Diagram Fosc : 100KHz EMI FILTER & RECTIFIERS RECTIFIERS & FILTER POWER SWITCHING De-Rating Curve +V(Red) -V(Black) 300 ± 20 AC/L(Brown) AC/N(Blue) FG (Green/Yellow) T case: Max. Case Temperature Sunpower Technology LLP Orion House, Calleva Park, Aldermaston, Berkshire RG7 8SN Tel: +44 (0)118 981 1001 • E-mail: sales@sunpower-uk.com

CLG-100 Series 100W IP67 Constant Voltage LED Lighting Power Supplies Power Factor Characteristics Efficiency vs Load (48V Model) Constant Current Mode 92 88 EFFICIENCY (%) Driving Method For LED Module A typical LED power supply would work in constant voltage mode (CV) or constant current mode (CC) to drive LEDs. 100 Constant Current area Constant Voltage area These power supplies can be operated at CV mode (with LED driver at Constant Voltage area) and CC mode (direct drive, at Constant Current Area) Typical LED power supply I-V curve Sunpower Technology LLP Orion House, Calleva Park,...