SYS1319-T3 series GREEN MODE Operating Temperature : Efficiency level (ErP) : Approvals / Marks : Features: Wide range Input (90 ~ 264)VAC / (47 ~ 63) Hz. For I.T.E. use only + RoHS conform. Over load, over voltage & short protection. Designed and certified also for cable IEC320-C7 & inlet C8 (T2). Output connector: standard: 2.1 x 5.5 x 11mm or customer requirement. Ripple & Noise [mV]p-p This model is certified for Uout=(5,6,9,12,15,16,18,19,20,24)V and Pout=(5~30)W is rising in steps of 1W Voltage 1A rms@ AC low line input and DC output full load 40/60Amax. @ power supply cold start, ambient temperature 25℃ @115Vac/230Vac nominal AC input. Leakage current Over load Over Voltage Current Surge Current max. Short Circuit Yes, Output to Ground, Auto recovery when fault has been removed. Short Current & Over Current can not exceed 8A max. after 1minute at nominal line input. Protection class Yes, to protect the power supply and system from damage Dielectric Strength 10ms @ AC nominal Input and Output full load MTBF Qualification 500,000 Calculated Hours at 25ºC, by Telcordia SR-332 Standard length of the cable 1,8m & It depends on customer requirements and upon specifications Efficiency (typical) >83.5% @ 240VAC input & Full load Power Consumption Max. 0.3Wrms @ AC nominal Input and Output min. load | some models have achieved efficiency level IV. Input Fuse 3000 ms max. @ AC low line input @ output full load Hold-up Time Operating: (8 ~ 90)% RH / Storage: (5 ~ 95)% RH non condensing protected against power line surges and any abnormal conditions CE | TUV/GS | CB | cULus | KC (Only for SYS1319-3012, SYS1319-3015) | FCC EMC

Mechanical case specification: Cable specification: 1185#18*1C + shield / 6FT (1830mm)